I believe the reinforced pair are from the '75 and as long as the center to center distance of the bolt holes is the same ...   01-01-2006 04:31 pm

I have started two Albums in the California section of the "JHP Photo Gallery".  The first is of the Summer Party at Bob Hillhouse home ...   12-11-2005 08:05 pm

When installing the Delta sway bar be sure to locate the location of the frame holes with the front springs loaded to ride hight attach ...   12-05-2005 04:36 pm

A better way to keep moisture out of the trunk and tank area is to drill a 1/4" hole between the gas filler depression and ...   11-30-2005 09:07 pm

It sounds like whoever did the conversion used a rear axel with leaf springs.  Otherwise why a broken shackle?  The Jensen Healey used a four link ...   11-20-2005 08:05 pm

OK here goes.  I bought my JH when I saw it in a salvage yard in 1983 and fell in love with its looks and the amount ...   10-11-2005 05:54 pm

The Jensen Healey is very light compared to most production sports cars. There are two reasons for removing weight, one to improve the power to ...   09-11-2005 05:05 pm

Just a note regarding rear suspension arms; after replacing the bushings and reassembling the rear suspension the bolts should be left finger tight until the ...   09-02-2005 05:31 pm

I added driving light under my front bumper, not legal but effective! ...   09-02-2005 05:17 pm

If you look at the axel and hub flanges you will see they are thincker where bolt holes are drilled so redrilling them would result ...   08-28-2005 04:33 pm

Try Delta Motorsports they have mats in brown and black for $45 and they are a perfect fit. ...   08-23-2005 04:13 pm

I just got floor mats from Delta, they fit perfectly and the price is reasonable at $45. They can be had in either brown or black. ...   08-23-2005 04:12 pm

After you remove the instrument cluster you will find three 3/8" nuts must be removed underneath where the dash meets the sheetmetal.  One can be ...   08-23-2005 04:05 pm

Anyone who thinks Jensen Healeys are ugly probably thinks the Aztec and Citroen 2CV are beautiful.  ...   07-30-2005 05:11 pm

I lowered the rear of my Jensen Healey by several inchs.  I have installed 26'' tires and it caused the rear to be rather high.  ...   06-24-2005 01:49 am

Looks great! Keep the reports coming! ...   06-15-2005 05:19 pm

Best to go with the recomdendations of the time manufacturer! ...   06-13-2005 02:48 pm

It can be done. You would have to do a complete disassembly and beed blast.  Many panels would have to be replaced especially the hood ...   05-14-2005 02:36 pm

Great looking car.  I hope you will provide some how to's on modification you have made.  Also race results and lessons learned about the Jensen ...   04-27-2005 05:09 pm

Don,  the  Jensen   wheel pattern is 4x4"  and 4x100mm wheels can be made to fit as the pattern is close.   I  don't believe close is ...   04-26-2005 04:06 pm

If you want wheels other than Panasport it is possible to have made wide 1" wheel adapters 4x4" to 4x100mm.  This will allow many more possibilities in ...   04-26-2005 07:24 am

CAUTION!! When considering sandbasting DO NOT use sand or go to a sanblasting company that does not do cars being restored.  There are other materials such ...   04-22-2005 04:35 pm

Thanks to all who have replied to Sports Rod.  I knew there must be kindred spirits out there.  I agree that for handling the lighter ...   04-22-2005 04:19 pm

It is neither better nor worse just different.  My first intention was to restore the Jensen until until I found the engine was in need ...   04-21-2005 03:55 pm

I know most of you are purists who disdain those with the temerity to tamper with the most excellent engineering of Jensen Healeys, however some ...   04-21-2005 03:42 am

Another important place to check for rust is under the fuel tank as water seeps through the filler neck well and then saturates  the pad ...   03-26-2005 03:27 pm

I have had my front suspension apart several times.  It is more dificult than the rear but doable. 1. Put the car on jackstands so you can ...   03-26-2005 03:20 pm