I had 19444 down a couple of years ago for overhaul and did the flywheel in a freinds shop with a 8 inch or so ...   10-17-2013 12:12 pm

I hope you have a level concrete floor possibly inside  to do the job.  The shop manual I have says pull the engine with the ...   10-16-2013 01:23 pm

If it's anything like the Webers, the throttle butterfly has to be completely closed in order to work .  If only slightly open the low ...   09-17-2013 03:03 pm

It doesn't sound like a main seal leak.  The rear main seal is in front of the flywheel and should not leak into the clutch ...   08-06-2013 11:54 am

Found a video of my car at a cruise in car show in New Smyrna, Fla. Wasn't expecting  it.  When finished  the screen fills up ...   07-08-2013 12:10 pm

Just a wild opinion, was the filter an exact replacement for the previous filter?  The blockage seems to be at the filter.  Some filters have ...   05-29-2013 11:06 am

I just replaced an old shrunken vinyl top on my 73  with a Robbins Canvas top (Rockauto.com) .  The front of the top never seems to ...   03-29-2013 12:09 pm

I replaced a set of rock hard Pirellis a couple of years ago with 175's and haven't regretted a minute of it. they are ...   03-26-2013 11:01 am

I've tried several ways with moderate success.  Currently using gasket cork  glued to the cover  using a non hardening sealer  and about 50 spring clothes ...   03-05-2013 12:42 pm

Next time it is at high idle check your throttle linkage to see if is returning to the idle position or staying open a bit. ...   02-26-2013 04:09 pm

It is not usually the fuel tank  since there is so much fuel between it and the carb.  More than likely it is in one ...   10-04-2012 01:28 pm

cough and stumble should be fuel system, float level or line blockage although my experience with stumble was usually too rich.  how are the plugs? ...   09-29-2012 11:06 am

It's probably has a fouled plug or missing electrically.  try pulling the plugs and looking for a fouled plug. If you have stock points ignition ...   07-10-2012 01:58 pm

Auto zone sells gm single wires for $52   and guarantees them for life ...   07-02-2012 10:34 pm

Had this joy a year ago and found no advice that worked. The problem is that the seal rope is just too small for the ...   05-08-2012 05:45 pm

Corroded electrical connectors and fuel leaks from dried out carb gaskets come to mind. The distributor is directly under the carburators and will ignite any ...   02-22-2012 01:11 pm

I've never had a chance to compare performance with another JH but in my experience, getting rid of the Strombergs for Webers / Dells , lightening ...   12-22-2011 10:32 am

Mine went in the trash a while back but I seem to remember a set screw somewhere in the slide that locks the needle in ...   12-13-2011 10:42 am

just my 2 cents,  I removed that foot rest next to the clutch pedal  and found the leg room situation much better. your left leg ...   11-23-2011 11:34 am

Correct me, someone, if I am wrong but the ignition light you speak of has nothing to do with the ignition system. When it is ...   11-11-2011 12:05 pm

Oil leaks have been my constant companion lately and I may have found a solution for one of them.   Getting valve covers to seal properly ...   08-23-2011 01:13 pm

Is the brake cylinder able to slide back and forth slightly , or is it frozen in place. Girling makes a one sided brake cylinder ...   08-18-2011 12:02 pm

here is a nice one in Florida, if a bit pricey http://daytona.craigslist.org/cto/2492021406.html ...   07-15-2011 04:56 pm

not any more but it is a sprinkler / well / pool pump seal  with a 1/2" shaft .  About $20.00 us.  aall I needed ...   06-18-2011 10:46 pm

I've had the engine out of this car twice since last november, once for the rear main seal and the second time for another rear ...   06-13-2011 11:51 pm

Was wondering before I start the teardown if the piston rings can be replaced without pulling the engine . With the head off the liners ...   06-13-2011 02:01 pm

I do believe you are running Stromberg single barrel carbs in which only  2 tubes will work, 1-2, and 3-4.  Furthermore you wont see the ...   05-31-2011 03:29 pm

In the late 80's Nissan used basically the same setup on the vg30i  v-6 engine for a couple of years before  going to a chain ...   04-29-2011 12:28 pm

mine went out on 19444 a while back and I retrofitted a monoshock from a mountain bike.  I is adjustable and looked cool. I think ...   02-09-2011 11:43 am

thanks, the oil pump needs primed and radiator installed and it should light right off.  But then it did before.  I didn't know that about  ...   01-15-2011 10:33 am

I recently pulledd the engine out of my 73 in order to replace the rear main oil seal (rope) . This requires removing the crankshaft ...   01-12-2011 01:42 pm

Was this car running when you bought it?  If so, something has happend in the meantime.   It may be several things like bad gas. stuck ...   01-06-2011 12:46 pm

I've done a few pump seals myself in my younger days, but the engine seals have to be cut off  square and butt up to ...   12-08-2010 11:25 pm

Well I suppose it's back to the drawing board on this rear seal change. The new seal leaks as bad as the old one and ...   12-08-2010 03:17 pm

Before you start disassembling big stuff, try checking to see if the clutch fork hasn't fallen off it's pivot. It can do that if the ...   12-02-2010 12:44 pm

Thanks but it's all repaired and installed.  The job because of all the mess was done outside and had to be done with minimum delay ...   11-09-2010 06:14 pm

Yes it's a mk1 , The mk2 oil seal doesn't sound like a picnic to change either.  I guess the accusump isn't   a good thing ...   11-05-2010 10:52 am

I just finished three days of pulling a very oily engine from 19444 in order to replace the rope rear main seal. I tried everything ...   11-04-2010 01:04 pm

For my money, Gorilla glue is the baddest.  It is a construction  adhesive that swells as it sets and it holds.  It may not be ...   10-07-2010 01:23 pm

Mine were too badly deteriorated. I ended up scraping them off and painting them. You can see the results in the gallery under Florida cars ...   08-14-2010 10:54 am