I am about to reinstall my flywheel with the new ring gear solidly welded on. However I just noticed looking at the photo that ...   04-29-2007 04:59 am

    My ignition switch has failed so I need to come up with a fix. Does anyone know if the MGB switch  & lock assembly ...   04-05-2007 02:16 am

    I just replaced my stock flywheel which I had tack welded the ring gear onto.(Because the high torque starter pushed the shrunk on ring ...   04-02-2007 12:12 pm

    The original was a Borg & Beck (which fit great) the replacement didn't have the same markings not sure who made it ...   02-14-2007 08:40 pm

After pulling the transmission to fix the starter ring gear I decided to replace the rear main seal and the clutch. Not that they were ...   02-14-2007 11:02 am

Thanks Norm,           That provides the answer I needed!  (Damm!!)  ...   01-19-2007 02:37 pm

I replaced the starter about 1 year ago with a high torque aftermarket one from Gustafson Machine Gear Reduction Starters. Prior to October it was ...   01-18-2007 05:02 pm

This is a photo of the ring gear thru the starter hole. Is this the correct position or should the gear be further forward? ...   01-17-2007 03:05 pm

    I am trying to troubleshoot a starting problem and I need to know the dimension from the starter mounting flange to the ring gear. ...   01-10-2007 07:21 pm

I was looking for more info on the lite weight Lotus flywheel mentioned in previous posts such as part no, weight , do I have ...   11-15-2006 08:56 pm

I have had good luck making a custom seal for that area using silicone RTV. I first covered the top of the door window and ...   04-04-2006 01:02 pm

I shipped my sons' Jeep from CT to Salt Lake last Thanksgiving with Bullseye Auto Transport Bullseye Auto Transport Phone Number: (877)216-6683Web Site:http://www.bullseyeshipping.com/homeLocation: Red Bluff, CA ...   02-03-2006 12:47 pm