I have a good size workshop 30x40 but my neighbor has a large workshop with a two post auto/truck lift which makes it easy. ...   06-14-2021 02:35 pm

JH20152 back on the road again. Removal/installation went smoothly. New clutch kit parts and flywheel resurfaced. I though the oil leak was from being in ...   06-13-2021 02:08 pm

Bruce, Thank you for the response and the caution note. ...   05-31-2021 12:47 pm

1. Does the oil sump need to be removed to replace the rear oil seal? 2. If careful installing the rear housing with the seal is ...   05-30-2021 06:17 pm

Gordon, Thanks for the info. I had previously cleaned and lightly oiled the pins and anything that rotated. I received a new brake rod assembly from ...   01-07-2021 02:17 pm

When I apply the parking brake lever the left rear wheel locks up (cannot rotate wheel). The right rear wheel will not lock up the ...   12-08-2020 05:24 pm

Tim, It's me again. Question for JH 20152. I pulled the intake cam housing carrier from the engine. The oil feed hole has not been reamed out ...   02-25-2020 07:52 pm

Bruce (redracer), Thanks for the info on shimming techniques. You, Tim Engel and others have provided a wealth of knowledge to the message board users. Especially ...   02-21-2020 05:17 pm

Tim, Could not find any of the supplied identifications on the camshaft collar. However stamped on the rear face of the camshaft behind the thrush washer ...   02-18-2020 01:44 pm

Tim, Thanks for the info. I will review and contact you later. I am now not in a hurry to get it on the road. Chuck ...   02-17-2020 12:55 pm

Esprit2 Tim Engel, I responded to myself in the 4th post in place of you. Would you look at the 4th post and respond to me regarding ...   02-16-2020 03:30 pm

Tim, I first removed the exhaust cam housing and naturally gravity took over and three shims hit the floor. Three stayed inside the vale stem retainers ...   02-14-2020 05:17 pm

Tim, Thank you very much for the technical response. Printed a copy of the response. Very thorough. I thought this would be the answer. I will ...   02-11-2020 02:25 am

JH #20152 rubber bumper born 2/75 engine B74 036394 purchased 11/19. Car is in vg shape no rust. I have been doing various projects, electrical, window ...   02-09-2020 05:21 pm

mechfeeney. Thanks for post for installing the window seals. I found the instructions excellent and it made it much easier to install the outer seals. The ...   01-29-2020 08:58 pm

1975 JH vin 20152, engine s/n B7403 6394, date of manufacture Feb. 24-1975(24-2-75). Running and very good condition. Color tangerine with black interior and top. ...   11-19-2019 03:18 pm