| ||||
|
Posts by factman10 | |
---|---|
7 posts | Showing posts 1-7 of 7 |
Engine & Transmission > Cam Pulleys (5 replies - 10938 views) Just about to start my first crank pulley, cam pulley and tensioner bearing replacement. Other than maintaining TDC, are there any other banana skins ... 05-01-2015 04:31 pm Carburetors > starting after a lay off (13 replies - 22122 views) Thanks everyone for the good tips. I just installed my other set of clean and re-gasketed carbs. Also back flushed all fuel lines ... 06-11-2014 03:57 pm Carburetors > starting after a lay off (13 replies - 22122 views) Hi, I have requested to add you to my contacts. At the moment I am rebuilding another set of replacement carbs and then I ... 06-07-2014 04:14 pm Carburetors > starting after a lay off (13 replies - 22122 views) Good idea Frank. At the moment I am rebuilding a spare set of carbs to replace those currently on the car. I will ... 06-07-2014 04:04 pm Carburetors > starting after a lay off (13 replies - 22122 views) Thanks for these suggestions. I did experience difficulty in holding the "O" rings in place, so I will check them again. At the ... 06-01-2014 06:09 pm Carburetors > starting after a lay off (13 replies - 22122 views) Many thanks. I will check the filter and replace. However, the car seems to rev up OK in neutral, I only experience the ... 06-01-2014 05:42 pm Carburetors > starting after a lay off (13 replies - 22122 views) I had my '73 off the road for about six months. It started up again with starter fluid but would not run on. I ... 05-31-2014 05:06 pm | |
Current time is 07:38 pm |