| ||||
|
Posts by Bob McDonald | |
---|---|
6 posts | Showing posts 1-6 of 6 |
Cooling > Still Running Hot! (17 replies - 37674 views) Dave-I have had the same problem when I was playing with the ignition curves.
If you have run on then make sure your not running over ... 09-19-2008 06:53 pm Electrical & Instruments > Short in Purple Wire "Ignition Off Wire Hot" Circuit (8 replies - 17083 views) Hi Lash
The wiring diagram shows the purple wire comes from the fuse box and
goes to the 9 way connector by the steering column and then ... 06-24-2008 04:03 pm Engine & Transmission > Clutch Operation (9 replies - 17125 views) Hi Dan
Your set-up looks great.
I used the ford throwout bearing with the healey forks
so I didn't have to machine transmission and with the unit ... 06-03-2008 06:43 pm Engine & Transmission > Clutch Operation (9 replies - 17125 views) Hi Joel
I wrote out what I've done and sent it to Greg but I didn't have any photos
so it was probably hard to follow and ... 06-02-2008 08:36 pm Engine & Transmission > Clutch Operation (9 replies - 17125 views) Dan
I have the same setup as you except the throwout bearing is ford and the
healey forks pins ground out to fit.That's were the 3 ... 06-02-2008 04:31 pm Engine & Transmission > Clutch Operation (9 replies - 17125 views) Hi Dan
I found that there are 3 different ford throwout bearings so depending on your
set-up you may need the longer one
Bob
... 05-30-2008 11:16 pm | |
Current time is 08:37 pm |