It’s obvious that my 907 J-H engine has been opened up before. Does anyone know how to tell if the valve tappets have been upgraded ...   09-18-2024 08:40 pm

Edward, I could not get the photos posted so I sent them to your e-mail adress. ...   11-03-2006 12:38 am

I'll get some photos posted right away. ...   10-31-2006 06:20 am

When closely examining the rear wheel bearings, I found that there is a spring and lip type of seal between the inner and outer races ...   10-29-2006 09:20 pm

The flange nut is off and the seal is replaced! For anyone interested, the nut is 30mm. The problem was the "keeper" to ...   09-16-2006 11:53 pm

Thanks for the tip Ron. I'll give it a try. ...   09-16-2006 03:25 pm

I would change the profusely leaking rear oil seal of my Getrag 5 speed if I could only get a socket to fit the flange ...   09-15-2006 02:37 am

Thank you Judson. This is exactly the info that I was looking for. I don't know why I searched on my own for ...   08-04-2005 07:28 am

Does anyone know the model number of the Getrag 5 speed transmission used on the later Jensen Healey? Is it an M51 or a ...   08-03-2005 06:42 pm

The easiest JH engine change that I have done was by removing the engine, transmission, and front suspension out from under the car as one ...   07-13-2005 10:56 pm