| ||||
|
Posts by kneff | |
---|---|
21 posts | Showing posts 1-21 of 21 |
Electrical & Instruments > Seat Belt Interlock? (1 reply - 7395 views) OK, so here's a strange one.
I went out to start my J-H today and nothing - no click, no starter. All other electric items (lights, ... 05-26-2006 04:03 am Miscellaneous > Hole in Delta header? (6 replies - 14676 views) Mark,
Thanks for the suggestions. Besides providing humor for me and my son, it's something I can try fairly easily.
As for the manifold-to-engine joint, how ... 09-16-2005 04:12 am Miscellaneous > Hole in Delta header? (6 replies - 14676 views) When I purchased my J-H, it had a Delta header that seemed to be in OK condition. No visible holes or rust. Aft ... 09-16-2005 12:37 am Suspension > Front suspension (53 replies - 98073 views) For all of you who have gone through your front/rear suspensions, do you have any advice on:
1) If you had it to do over, would ... 09-02-2005 04:40 am Body & interior stuff > Replacement seat belts (7 replies - 20855 views) Adam,
Did you have to remove the belt from the reel in order to remove the new buckle and replace it with the old one? ... 08-25-2005 03:22 am Miscellaneous > Installing Delta's New Exhaust System (13 replies - 28691 views) Mark, you wouldn't happen to have any undercar photos of the exhaust system after installation, would you?
I purchased the Delta system recently. I've cut ... 08-06-2005 12:42 am Miscellaneous > It runs - 1st time in 15 years (6 replies - 13974 views) You should not need a smog test, as your JH is >30 years old. I registered my 1974 JH in California (San Jose) a ... 08-06-2005 12:36 am Body & interior stuff > Replacement seat belts (7 replies - 20855 views) I'm pretty sure my original seat belts are no longer of any use. I don't think that the belts will lock under any condition.
What ... 06-28-2005 06:34 pm Body & interior stuff > Tonneau (1 reply - 8210 views) I recently purchased a tonneau from Delta Motorsports. It arrived and appears to be the correct size and of good quality, but it came ... 06-28-2005 06:18 pm Miscellaneous > Installing Delta's New Exhaust System (13 replies - 28691 views) Mark,
Was no welding required? I thought that, as delivered, some welding would be required to assemble the system. I'm trying to decide what ... 06-28-2005 05:57 pm Suspension > Lower stance (5 replies - 15846 views) Did you fit the 205/60's on the original wheels?
Thanks,
Ken ... 06-23-2005 10:27 pm Engine & Transmission > Engine and Transmission Mounts (18 replies - 68780 views) See- I knew someone would have a clever answer! Putting a wrench on the top nut and then rotating the mount hadn't occurred to ... 06-02-2005 06:16 pm Engine & Transmission > Engine and Transmission Mounts (18 replies - 68780 views) Last weekend I attempted to replace the engine mounts. I say "attempted" because I only succeeded in replacing the right (intake side) mount. ... 06-02-2005 04:02 pm Ignition > Timing (12 replies - 29604 views) Mark,
I have a 1974 J-H. If I understand correctly, then, my exhaust cam gear is mounted backward, since it is marked with 110 In ... 05-24-2005 06:16 pm Ignition > Timing (12 replies - 29604 views) I'm confused about what I SHOULD be seeing on my cam sprockets. I have a 1974 J-H, and each cam sprocket has two markings: ... 05-24-2005 03:50 pm Engine & Transmission > Engine and Transmission Mounts (18 replies - 68780 views) I installed the Delta mount the weekend before last, and everything went so smoothly that I couldn't believe it! Many, many thanks, Mark, for ... 05-24-2005 12:00 am Engine & Transmission > Engine and Transmission Mounts (18 replies - 68780 views) Mark,
Is the transmission mount working OK without being shimmed? I just took my old one off, and I have a new replacement (from Delta). ... 05-14-2005 04:02 am Engine & Transmission > Engine and Transmission Mounts (18 replies - 68780 views) I put the rear of the car up on jack stands, and this is what I found:
1) The transmission mount is visibly toast. The ... 05-07-2005 02:33 am Engine & Transmission > Engine and Transmission Mounts (18 replies - 68780 views) My shifter impacts the console when shifted into 2nd. Is that a transmission mount-related issue? How can I tell? ... 05-05-2005 11:23 pm Electrical & Instruments > Electrical (4 replies - 12190 views) I have exactly the opposite problem. My turn signals work fine, but the emergency flashers don't work. I'm assuming that I have a ... 04-29-2005 06:52 pm Body & interior stuff > Gas Struts For Your Bonnet (Hood) (15 replies - 23257 views) How high do these struts raise the hood? In the '74 J-H I bought this weekend (from Tim Fultz), someone in the past replaced ... 04-27-2005 12:08 am | |
Current time is 07:51 pm |