| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Repairing a cracked 907 block | Rate Topic |
| Author | Post |
|---|
| Posted: 12-01-2006 01:27 am |
|
1st Post |
|
Erzulis Boat Member
|
Is it an acceptable practice to weld up a small crack in the water jacket to save a block?
|
||||||||||||||
| |||||||||||||||
| Posted: 12-01-2006 11:32 am |
|
2nd Post |
|
normv Member 
|
Yes but why did it crack in the first place, You need to grind a V to ensure penatration. and I recomend drilling at each end as this stops it continuing, Often as you weld it.
|
|||||||||||||
| ||||||||||||||
| Posted: 12-01-2006 03:20 pm |
|
3rd Post |
|
Erzulis Boat Member
|
The repair was already present. After stripping the block, the telltale weld penetration bead was present at the base of the water jacket near the cylinder bore. Externally,but very faint, were the die-grinder marks. The block is currently undergoing a dye penetrant test, but I was curious if the 907 was normally repaired in this manner.
|
||||||||||||||
| |||||||||||||||
| Posted: 12-01-2006 03:40 pm |
|
4th Post |
|
Jensen Healey Super Moderator 
|
Where are you located? I have a spare if you need it. Kurt Housh
|
|||||||||||||
| ||||||||||||||
| Posted: 12-05-2006 04:17 pm |
|
5th Post |
|
Erzulis Boat Member
|
Thanks for above offer. How often has anyone encountered this type of repair? Any potential problems? Did the factory repair casting flaws? Thanks-
|
||||||||||||||
| |||||||||||||||
| Current time is 10:27 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Repairing a cracked 907 block | Top |
