| ||||
| ||||
| Moderated by: Greg Fletcher | Page:   1 2 |
|
|||||||||||||
| adjusting valves | Rate Topic |
| Author | Post |
|---|
| Posted: 04-06-2009 01:29 am |
|
21st Post |
|
Gary Martin JH 15371 Member
|
Thanks Judson, I was hoping you would respond. I will install it as is and run it for a few thousand miles and re-check clearances. I want to run it awhile before deciding on changing the exhaust cam. We finally have some nice weather here in Oregon which is helping me make progress on the car. Engine should go in the car tomorrow. Need to install the tank and fuel pump plus a few other things, but should be ready to fire it up in a couple of weeks. I have been posting pictures of my progress in the gallery under JH of Oregon, 15371 progress. Gary
|
||||||||||||||
| |||||||||||||||
| Posted: 04-07-2009 01:22 pm |
|
22nd Post |
|
Jensenman Member
|
Has anyone considered or tried making an .010 aluminum cam tower gasket and using 518 on each side of that? That would eliminate the gasket crush problem. It's not unprecedented; Datsuns used to have 'head savers' which were steel shims for the cam towers, used when the head was resurfaced too much or the valve tips were too high. On valve clearances: I learned the hard way many years ago on motorcycles to always set them a little loose (an extra .001-.002). As the valve contacts the seat it will slowly wear and 'grow' out of the head, effectively closing the clearances and this leads to burnt valves, particularly on the exhaust side. Last edited on 04-07-2009 08:19 pm by Jensenman |
|||||||||||||
| ||||||||||||||
| Posted: 04-07-2009 02:47 pm |
|
23rd Post |
|
Jensen Healey Super Moderator 
|
I'm guessing the intake side was tightened up to gain a couple thousandths of lift. Race engines get much more attention than a street engines so it would never be a problem. If you are driving on the street and don't want to check your clearances very often, adjust them according to the manual. I would drive it the way it is and adjust later! Kurt
|
||||||||||||||
| |||||||||||||||
| Posted: 04-08-2009 12:01 am |
|
24th Post |
|
Gary Martin JH 15371 Member
|
Thanks everyone for the comments. I was initially checking the clearance with the lobes directly opposite the cam follower. I went back and rechecked, and I found that if I turn the lobes a few degrees past directly opposite the valve I gain another .015 to .02 in clearance! This puts me right in the .06 to .07 range for the intakes. The manual does not mention this. I just says to adjust on the heal of the cam lobe. Interesting. Gary
|
|||||||||||||
| ||||||||||||||
| Current time is 05:57 am | Page: 1 2 |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > adjusting valves | Top |
