| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| DOOR PANELS | Rate Topic |
| Author | Post |
|---|
| Posted: 11-29-2010 01:48 am |
|
1st Post |
|
txk Member
|
THIS MAY SEEM BASIC TO MOST OF YOU, BUT I NEED TO KNOW HOW TO REMOVE THE DOOR PANELS. THANKS FOR THE HELP. GARY SMITH
|
||||||||||||||
| |||||||||||||||
| Posted: 11-29-2010 07:04 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Gary, take the arm rest off, 2 screws, window crank, 1 screw, any stainless trim you might or might not have, and then from the bottom use a srew driver or flat blade scrapper and pry away from door, there are a bunch of plastic snaps that hold it in place that go along the bottom and both ends, the top has a lip you just lift the panel up and off. You will probably brake some of the snaps doing it, so save a good one and go to an auto upholstery place, they should have replacements or at lleast tell you were to get them. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 11-29-2010 07:51 pm |
|
3rd Post |
|
txk Member
|
BRETT--THANKS A LOT FOR INFO. HAVE HADE MGB'S IN THE PAST AND FROM WHAT YOU DESCRIBED IT IS THE SAME. I HAVE NEW WINDOW CRANK AND DOOR LATCH HARDWARE WHICH WILL HELP THE APPREARANCE. GARY SMITH
|
||||||||||||||
| |||||||||||||||
| Current time is 10:32 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > DOOR PANELS | Top |
