| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Steering Wheel Badge | Rating: 
|
| Author | Post |
|---|
| Posted: 09-24-2013 12:40 am |
|
1st Post |
|
cgillies Member
|
Just bought a steering wheel badge for my Feb 1975 JH. However it was too big. Were there different sizes made of the metal insert badges? C
|
||||||||||||||
| |||||||||||||||
| Posted: 09-24-2013 01:57 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
There are two badges, one is rubber and black, the other metal, are you sure it's a steering wheel badge and not the hood one ??. they do run on the large side though thats why alot of steering wheels have chips out of them around the badge. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 09-27-2013 03:58 pm |
|
3rd Post |
|
Gary Martin JH 15371 Member
|
My 74 mark II #15371 has the black rubber badge on the steering wheel. John Kimbrough's 74 which was #15375 had the metal one. Must have been built around the same time. I never understood why the two different badges. Was it some trim option, or just the British grabing whatever was on the shelf at the time ?
|
||||||||||||||
| |||||||||||||||
| Posted: 09-28-2013 02:05 pm |
|
4th Post |
|
Brett Gibson JH5 20497 Member
|
Gary, I always thought it had to do with the early version of the center consul, the one that looks like a tupperware tray all black plastic. who knows for sure. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 07-30-2014 02:06 pm |
|
5th Post |
|
srq2002 Member
|
Forty years back we bought a Mk II (not Tupperware console), and it came with the rubber insert. My impression is that the metal was a later change. My current early '74 Mk II has rubber, my previous '75 had metal. Likely there would have been some overlap around the time of the change. Heck, the Mk II we bought forty years ago had one of the troublesome early engines; records show that out of the blue they stuck early engines (I guess were laying around) in two sequential cars, even though the improved engine was by then the norm.
|
||||||||||||||
| |||||||||||||||
| Posted: 07-31-2014 02:18 am |
|
6th Post |
|
Frank Schwartz Member
|
If the steering wheel is made for the metal badge, it can be inserted...get some good soapy water and slide the badge in place and then with a flat dinner ware knife, prise it in while it is still wet and soapy...then clean it all up..
|
|||||||||||||
| ||||||||||||||
| Current time is 07:15 am | |
| > Jensen Healey & Jensen GT Tech > Accessories > Steering Wheel Badge | Top |
