| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Bushing replacement on front axle control rods | Rate Topic |
| Author | Post |
|---|
| Posted: 07-12-2005 10:50 pm |
|
1st Post |
|
Frank Schwartz Guest
|
Well, I need to replace the bushings, part numbers 52, 53, 54 and 55 on the control rod #50. Before I dive in, I might say that the service manual says little or nothing about it. If I remove the rear nut #51 can I slid the whole thing forward enough to replace the bushing and sleeve without having to remove the control rod where it bolts to the lower arm?
|
||||||||||||||
| |||||||||||||||
| Posted: 07-13-2005 01:34 am |
|
2nd Post |
|
Greg Fletcher Administrator 
|
I'm remembering that those front bolts will need to be removed so that you can pull the rod out of the subframe opening and remove the other bushing. Now is a good time to go through the entire front suspension, if needed. You'll need to get the front end realigned whenever those bushing get changed.
|
|||||||||||||
| ||||||||||||||
| Current time is 03:25 pm | |
| > Jensen Healey & Jensen GT Tech > Suspension > Bushing replacement on front axle control rods | Top |
