| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Ball joint nuts - how to get them on? | Rating: 
|
| Author | Post |
|---|
| Posted: 04-24-2005 11:08 pm |
|
1st Post |
|
Ron Earp Member 
|
I've got a problem with tightening my nuts on my ball joint shafts. I've got new ball joints on my front suspension arms and I'm using the original split locking type nuts. Problem is, the shaft of the ball joint spins when you try to tighten it. There is not enough room there to use pliers to hold the shaft. So what to do? I thought to use two non-locking nuts and double nut it, or, one non-locking nut and drill the shaft to accept a cotter pin. Any ideas? Anyone know the thread size/pitch so I can get replacement nuts? Ron
|
||||||||||||||
| |||||||||||||||
| Posted: 04-24-2005 11:40 pm |
|
2nd Post |
|
Jim Sohl Member
|
Ron, What is supposed to happen is that the interference fit between the ball joint shaft and the knuckle is tight enough to prevent the shaft from turning. Since yours is turning, I would suspect that the interference fit is being prevented from seating fully. This could be foreign debris, dirt, oil or grease, corrosion, or scoring. In any event, disassemble the shaft from the knuckle and CLEAN all surfaces very thoroughly. The surfaces should be smooth and dry. Upon re-assembly, rap the bottom of the ball joint with a rubber hammer several times. If the shaft and knuckle fit properly, the shaft will be seated firmly enough to prevent rotation. An interference fit is a type of press fit where the two parts are not bored at the same angle. Usually, the receiving part, the knuckle, has one degree or so additional opening than the fitting part, the shaft. Once seated, interference fit parts may require special tools or a press to drive them back apart. I hope this helps. If not, I’m not familiar with using loctite or similar airless adhesives. I would consult someone with more experience than I for further advice.
|
|||||||||||||
| ||||||||||||||
| Posted: 04-25-2005 12:20 am |
|
3rd Post |
|
Ron Earp Member
|
I'll try that Jim. I thought to push or put pressure on the assembly while tightening them, but ran out of time Thursday night. There is a lot of grease on the things too, and I am sure that isn't helping this particular situation. I'll give it a try, Ron
|
||||||||||||||
| |||||||||||||||
| Posted: 04-25-2005 01:12 pm |
|
4th Post |
|
Mitch Ware Member 
|
Once you get the nut on the bottom of the ball joint and it starts spinning, put a pry bar or long screw driver between the top of the ball joint and the control arm. Lift up and put it under pressure(it doesn't take much). This will keep it from spinning while tightening. Mitch 1974 JH-5 #111119670 1971 TR-6 #CC66950LO
|
|||||||||||||
| ||||||||||||||
| Current time is 11:29 pm | |
| > Jensen Healey & Jensen GT Tech > Suspension > Ball joint nuts - how to get them on? | Top |
