| ||||
> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Correct the reading for JH tacho after fitting electronic ignition |
Moderated by: Greg Fletcher |
|
Correct the reading for JH tacho after fitting electronic ignition | Rate Topic |
Author | Post |
---|
Posted: 12-15-2020 01:37 pm |
|
1st Post |
adamalfa Member
|
Hi Guys, has anyone got any tips on how I can make my tachometer show the right revs now that I have fitted and electronic distributor? It reads really high now. I have heard that you need to put a resistor in the circuit somewhere or maybe run the feed wire from somewhere else. If anyone has done this before and cured the problem then a workable fix would be greatly appreciated
|
||||||||||||||
|
Posted: 12-15-2020 02:18 pm |
|
2nd Post |
subwoofer Member
|
Install a Spiyda conversion: https://www.spiyda.com/smiths-rvi-rvc-conversion-external.html This allows you to feed the coil directly from any switched circuit, eliminating a long chain of failure points. -- Joachim
|
|||||||||||||
|
Posted: 12-15-2020 03:59 pm |
|
3rd Post |
adamalfa Member
|
Fantastic, I shall give it a go :-)
|
||||||||||||||
|
Posted: 12-15-2020 05:06 pm |
|
4th Post |
subwoofer Member
|
The one you really want is this one, but for some reason I didn't see it in there web shop: "RVI-RVC conversion board" Shoot them an email and ask. -- Joachim Last edited on 12-15-2020 05:07 pm by subwoofer |
|||||||||||||
|
Current time is 06:33 pm | |
> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Correct the reading for JH tacho after fitting electronic ignition | Top |