| ||||
> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Starter running via the Ghost of Lucas? |
| ||||
> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Starter running via the Ghost of Lucas? |
| Moderated by: Greg Fletcher | Page:   1 2 |
|
|||||||||||||
| Starter running via the Ghost of Lucas? | Rating: 
|
| Author | Post |
|---|
| Posted: 08-19-2013 10:56 pm |
|
21st Post |
|
Jim Ketcham Member
|
The lower voltage via the ballast is supposed to benefit contact breaker point life. If you are using Petronix or equivalent setup you do not need to worry about the ballast as long as you have a coil that can handle continuous 12v.
|
||||||||||||||
| |||||||||||||||
| Posted: 08-21-2013 12:57 am |
|
22nd Post |
|
answerman Member
|
Right... I do still have the stock points. My question was specific to the Lucas Sport Coil from the club store. Does it require a ballast resistor, or is it a straight 12v coil? That was I could just eliminate the whole ballast resistor and extra connection to the solenoid.
|
|||||||||||||
| ||||||||||||||
| Posted: 08-21-2013 01:49 am |
|
23rd Post |
|
Jim Ketcham Member
|
I am not familiar with the Lucas Sport coil but you can check it with an ohm meter to see if it has internal resistance of 3 ohms or more. My recollection is a straight coil will give about 1.5 ohms resistance.
|
||||||||||||||
| |||||||||||||||
| Posted: 08-21-2013 01:56 am |
|
24th Post |
|
Jim Ketcham Member
|
Lucas Sport Coil DB105 has internal resistance of 3 ohms so it does NOT require ballast resistor.
|
|||||||||||||
| ||||||||||||||
| Current time is 06:53 pm | Page: 1 2 |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Starter running via the Ghost of Lucas? | Top |
