| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Resistor wire | Rating: 
|
| Author | Post |
|---|
| Posted: 04-21-2012 07:57 pm |
|
1st Post |
|
Mitch Ware Member 
|
How many volts should be coming down the resistor wire from the tach to the coil? I've got about 2.5, that seems like way too little. If it is, why would that be? Mitch Ware #19670 #11002
|
||||||||||||||
| |||||||||||||||
| Posted: 10-11-2012 08:40 pm |
|
2nd Post |
|
answerman Member
|
I just kind of asked the same question in a different thread and haven't gotten a response yet. I was asking what the actual resistance of the wire (or ballast resistor, which is what I have) should be.
|
|||||||||||||
| ||||||||||||||
| Posted: 10-11-2012 11:05 pm |
|
3rd Post |
|
chiromaster Member
|
I just pulled off the resistor wire off the + side of the coil and got 11.60v
|
||||||||||||||
| |||||||||||||||
| Posted: 10-17-2012 05:37 pm |
|
4th Post |
|
subwoofer Member
|
chiromaster wrote:I just pulled off the resistor wire off the + side of the coil and got 11.60v Opening the circuit like that will always get you the battery voltage, no matter the value of the resistor. My suggestion would be to get rid of the resistor (wire), install a 12V coil - like a Lucas Sport Coil or a blue Bosch coil - and a Pertronix Ignitor-II. You will not regret it, and the tach will still work. No points to set ever again, and easier starting. -- Joachim
|
|||||||||||||
| ||||||||||||||
| Posted: 10-17-2012 05:39 pm |
|
5th Post |
|
subwoofer Member
|
Mitch Ware wrote:How many volts should be coming down the resistor wire from the tach to the coil? I've got about 2.5, that seems like way too little. If it is, why would that be? Could be: 1. You have a flaky connection somewhere adding resistance to the circuit. 2. The coil is a low-resistance type 3. the coil has an internal short -- Joachim
|
||||||||||||||
| |||||||||||||||
| Current time is 09:58 pm | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Resistor wire | Top |
