Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher Page:  First Page Previous Page  1  2   
New Topic Reply Printer Friendly
Brakes  Rate Topic 
AuthorPost
 Posted: 07-15-2017 11:41 am
  PM Quote Reply
21st Post
Wizardwings
Member
 

Joined: 07-11-2017
Location:  
Posts: 1
Status: 
Offline
I have received the file from jomac and taken his drawings for the mounting plates to a shop to have water jet cutouts made, if any one is interested i can have others cut at the same time, I dont know the cost yet but if your interested, let me know.

Back To Top PM Quote Reply  

 Posted: 07-15-2017 12:41 pm
  PM Quote Reply
22nd Post
jomac
Member
 

Joined: 09-16-2016
Location:  
Posts: 71
Status: 
Offline
Rear Ebrake installation, I sent out a revised version 1.0 to all I sent out copies of the first version. I added a tactical and tuning section . I added 2 rear springs to the Ebrake cable, one compression the other tension. The reason was to take up the slack when using the original JH linkage. Tight adjustment is key I set my Ebrake to slight drag to rotor and after driving they seat themselves. My Ebrakes perform same as stock .
Also, crosscar Ebrake rod shape does not interfere with bump stop, when using my caliper bracket design angle, it was setup to clear other components any change higher or lower would impact your install clearances.

Back To Top PM Quote Reply

 Posted: 01-26-2022 03:51 am
  PM Quote Reply
23rd Post
atgparker
Member


Joined: 06-23-2013
Location: Mission Viejo, California USA
Posts: 90
Status: 
Offline
How it looks from the wheel well. Note PVC pipe used to center CRX disk on the axle.

Attachment: WP_20170514_004.jpg (Downloaded 43 times)

Last edited on 01-26-2022 03:57 am by atgparker

Back To Top PM Quote Reply  

 Posted: 01-26-2022 03:52 am
  PM Quote Reply
24th Post
atgparker
Member


Joined: 06-23-2013
Location: Mission Viejo, California USA
Posts: 90
Status: 
Offline
All thread and clevis to the OEM brake lever with unpainted toggle bar that was lacking the swivel at the center when I took this picture.

Attachment: WP_20170514_003.jpg (Downloaded 43 times)

Last edited on 01-27-2022 09:51 pm by atgparker

Back To Top PM Quote Reply

Current time is 05:55 am Page:  First Page Previous Page  1  2     
> Jensen Healey & Jensen GT Tech > Brakes > Brakes Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems