| ||||
Moderated by: Greg Fletcher |
|
Ignition Issues,engine quits when hot! | Rate Topic |
Author | Post |
---|
Posted: 10-24-2016 03:33 pm |
|
1st Post |
rovohn Member
|
I have a 76 GT with points ignition,recently the car has decided to either quit or refuse to start when hot or at running temp and the coil is quite warm.If I let the car cool down for about 15-30 mins it will start again. Anyone have any ideas,Coil,condenser,ballast? Cheers,John
|
||||||||||||||
|
Posted: 10-24-2016 06:14 pm |
|
2nd Post |
redracer Member
|
Was everything running OK until recently? If you do change the coil, be sure it is a 1.5 ohm one as the GTs have the 1.5 nickel-chromium resistive wire going to it(giving 3 ohm for "RUN" condition). We usually "shotgunned" the ignition items(points, plugs, wires, rotor, condenser, cap)so we can start from scratch. We have had BRAND NEW points bad, as there was a little too much clamping down on the riveted fulcrum post, causing the dwell to increase to the point of stopping the engine running. As for coils, I have rarely seen one go bad on our J-Hs or Healeys, the few exceptions being oil oozing from the top.
|
|||||||||||||
|
Posted: 10-24-2016 06:31 pm |
|
3rd Post |
rovohn Member
|
Yes it was just recently,it ran great before. I think I will buy a new 1.5 ohm coil and see what happens. All of the other components are working ok,that being said I will check the points and replace the condenser Cheers,John
|
||||||||||||||
|
Posted: 10-25-2016 07:11 am |
|
4th Post |
subwoofer Member
|
Did you change the rotor (semi-)recently? If you have a rotor with a metal rivet in it holding the conductor to the rotor plastic, that could be your problem. I chased a misfire-while-hot problem for over two years before someone alerted me of the rotor problem. -- Joachim
|
|||||||||||||
|
Posted: 11-02-2016 05:32 pm |
|
5th Post |
rovohn Member
|
I replaced the coil with a 1.5 ohm,had it out for a good run this past Sunday ran great,let's hope it stays that way.
|
||||||||||||||
|
Current time is 08:52 pm | |
> Jensen Healey & Jensen GT Tech > Ignition > Ignition Issues,engine quits when hot! | Top |