| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Having trouble re-installing the distrubtor | Rating: 
|
| Author | Post |
|---|
| Posted: 08-26-2014 05:59 pm |
|
1st Post |
|
mdutch Member 
|
Having a devil of a time getting the distributor seated properly. My understanding is, I have to move the rotor to engage the bottom of the shaft and its offset key into the distro drive shaft. Is that correct? I would think if the rotor is still turning freely then the shaft is not engaged. It doesn't look like the body of the distro is fully engaged with the clamp and the rotor still spins. Am I correct?
|
||||||||||||||
| |||||||||||||||
| Posted: 08-26-2014 08:11 pm |
|
2nd Post |
|
subwoofer Member
|
The whole thing is spring loaded! You have to seat it, then hold it in place with one hand while tightening with the other.
|
|||||||||||||
| ||||||||||||||
| Posted: 08-26-2014 08:50 pm |
|
3rd Post |
|
mdutch Member
|
Thanks, after the third round of cussing, it went in just fine.
|
||||||||||||||
| |||||||||||||||
| Posted: 08-28-2014 09:12 am |
|
4th Post |
|
roland11a Member
|
Ive just fitted mine with a new "O" ring. What a pig to get in against the spring!!
|
|||||||||||||
| ||||||||||||||
| Current time is 03:06 pm | |
| > Jensen Healey & Jensen GT Tech > Ignition > Having trouble re-installing the distrubtor | Top |
