| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| emulsion tubes stuck in DHLA45 | Rate Topic |
| Author | Post |
|---|
| Posted: 04-28-2014 04:39 pm |
|
1st Post |
|
Jim McDonald Member
|
I am trying to rebuild my carbs, and the emulsion tubes and main jets are stuck in the carb body. I have soaked them in carb cleaner for a while without any luck. Any ideas? Thanks, Jim McDonald
|
||||||||||||||
| |||||||||||||||
| Posted: 04-28-2014 11:03 pm |
|
2nd Post |
|
Jensen Healey Super Moderator 
|
Hi Jim, Try a 50/50 mix of auto tranny fluid mixed with acetone. It's called "weasel piss". Soak up to 4 days. This stuff really works! Tap the screwdriver with a hammer while trying to remove. Not too hard. Apply cold to the brass using a can of computer duster, upside down. Try again. Kurt
|
|||||||||||||
| ||||||||||||||
| Posted: 04-29-2014 03:26 pm |
|
3rd Post |
|
Jim McDonald Member
|
Thanks for the suggestions, I'll give them a try. Actually the screws came off, it's just the tubes that are stuck, so I don't really have much to pull on.
|
||||||||||||||
| |||||||||||||||
| Posted: 04-29-2014 03:34 pm |
|
4th Post |
|
Jensen Healey Super Moderator
|
In that case, an EZ-out will come in handy.
|
|||||||||||||
| ||||||||||||||
| Posted: 04-29-2014 10:00 pm |
|
5th Post |
|
Jim McDonald Member
|
The EZ-out worked! Thanks for your help.
|
||||||||||||||
| |||||||||||||||
| Current time is 08:08 pm | |
| > Jensen Healey & Jensen GT Tech > Carburetors > emulsion tubes stuck in DHLA45 | Top |
