| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Help with Throttle Cable Replacement | Rating: 
|
| Author | Post |
|---|
| Posted: 01-23-2012 04:07 am |
|
1st Post |
|
Somebodystopme!! Member 
|
As the subject line says I am looking for help with replacing the throttle cable. To be exact I am looking to find out what the easiest way to get at the cable attachment on the pedal. It is locked into place with a small clip which I could easily remove with a long small screwdriver but it appears there would be no chance of getting it back on as I cant get my hands in the little space of the pedal box. Ideas??
|
||||||||||||||
| |||||||||||||||
| Posted: 01-23-2012 01:58 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Long handle needle nose pliers, had the same issue so went and bought a set amazing how much easier it is to reach that stuff with them. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 01-23-2012 07:49 pm |
|
3rd Post |
|
Somebodystopme!! Member
|
Did you go at it from through the firewall or up through the floorboard in the pedal box? Thanks for the insight!!
|
||||||||||||||
| |||||||||||||||
| Posted: 01-24-2012 05:00 pm |
|
4th Post |
|
Brett Gibson JH5 20497 Member
|
Went at it from under but removed the steering wheel first for the extra space, going at it thru the engine bay is easier but it means distrubing the pedal box seal something I dont like to do.......... Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 01-29-2012 10:05 pm |
|
5th Post |
|
Somebodystopme!! Member
|
Thanks for the help! I got it replaced and everythging works great now. I must have looked funny doing it though. I had my legs over the headrest and head down by the pedal box. Now onto the steering column bushing. (That one does not look fun)
|
||||||||||||||
| |||||||||||||||
| Posted: 01-31-2012 02:11 pm |
|
6th Post |
|
Brett Gibson JH5 20497 Member
|
As for the steering bushing actually the job is not that bad, remove the shaft from the steering wheel to the rack out of the way at the firewall, undo the two small screws and remove the plate that holds the cheap plastic crap bushing. Now if you bought a Delta plastic replacement bushing as I did take it to a machine shop and have them fab it out of brass and install that one otherwise at some point you will be doing this job all over again down the road. Hope this helps. Brett
|
|||||||||||||
| ||||||||||||||
| Current time is 05:41 pm | |
| > Jensen Healey & Jensen GT Tech > Carburetors > Help with Throttle Cable Replacement | Top |
