| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| no start - getting air, fuel and spark......carbs? | Rating: 
|
| Author | Post |
|---|
| Posted: 02-06-2010 08:38 pm |
|
1st Post |
|
flatlanderep Member 
|
1973 JH with strombergs. It sat during the huge cold snap we had here in the south and now will not start. I've checked for spark and its good. I've checked for fuel and its good. I've check for air and its good. Put in a new battery too. I'm stumped. Is a carb adjustment in order? I just don't understand how a carb would get out of whack just because it sat for a week. I'm not sure what else to do. Please help me get it running.
|
||||||||||||||
| |||||||||||||||
| Posted: 02-06-2010 11:21 pm |
|
2nd Post |
|
Sander Member 
|
Spark ... fuel ... Have you pulled the spark plugs? They may be fouled.
|
|||||||||||||
| ||||||||||||||
| Posted: 02-07-2010 04:55 pm |
|
3rd Post |
|
Brett Gibson JH5 20497 Member
|
Not sure just how you checked spark and fuel, but lets say you have 2 to 3 lb's of fuel pressure at the carb's, and you have spark at each plug, my next thought would be is it all arriving on time, could you have skipped a tooth on the timing belt. Could the cold have created condensation that froze and is sapping the spark off, could the gas line be partially frozen, or water that is frozen in the float bowls. I wouldn't go adjusting the carbs right now if they were working fine before, but I'd advise taking a look at the basic timing, crank and cams, then draining the float bowls. So many possibilities, let us know what you find. Brett Sander, time for you to go to the Nationals agian isn't it ???
|
||||||||||||||
| |||||||||||||||
| Posted: 02-07-2010 06:03 pm |
|
4th Post |
|
flatlanderep Member
|
i guess that was my next question. how do you drain the floats bowls on the stroms?
|
|||||||||||||
| ||||||||||||||
| Posted: 02-07-2010 09:43 pm |
|
5th Post |
|
Brett Gibson JH5 20497 Member
|
flatlanderep wrote: i guess that was my next question. how do you drain the floats bowls on the stroms? Pretty simple really, just feel under each carb and you should detect a round brass plug in the middle of each, 3/4" dia. its only held in by a O-ring, so just wiggle it while pulling down and it should come out, if it's a bit stuck use a screw driver to wedge it but be careful the plug housing is actually plastic. If you should bust it most Brit place's have new ones. If you can, replace the o-ring with a new one, or at least smear it with a gasoline proof gasket compound when putting back in. Brett
|
||||||||||||||
| |||||||||||||||
| Posted: 04-22-2010 12:21 am |
|
6th Post |
|
Circmand Member
|
now you can be sure you have an authentic british sports car
|
|||||||||||||
| ||||||||||||||
| Posted: 04-25-2010 11:03 pm |
|
7th Post |
|
Steve Jarvis Member
|
I just replaced it on the front carb as it was leaking. I think you need to remove the bowl and press from the inside to remove the plug safely. There are four small tabs on the plastic that required some coaxing to get out.
|
||||||||||||||
| |||||||||||||||
| Current time is 09:24 pm | |
| > Jensen Healey & Jensen GT Tech > Carburetors > no start - getting air, fuel and spark......carbs? | Top |
