| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Fitting Radiator & Shroud with A/C System | Rate Topic |
| Author | Post |
|---|
| Posted: 11-20-2007 04:51 am |
|
1st Post |
|
Dan Eiland Member
|
I just fitted my engine and Ford T5 transmission into my car for a trial fit with my A/C compressor installed and it fits fine with one exception--no room for my radiator fan shroud. Now I'm thinking of modifying the front sheetmetal to move the radiator forward a couple inches so I have enough room to get my fan shroud into the engine compartment and still have enough room up front to fit my A/C condensor and electric fans as well as my oil cooler. ...................Move forward an hour...I just came from my garage where I just pulled my radiator and fan shroud off the shelf and installed them into my engine compartment--or at least tried. The radiator fits fine but the fan shroud just won't fit. The crankshaft pulley used with the A/C compressor is just a hair too far forward. Is it possible to move the engine back about a quarter inch? I have enough room at the back of the engine compartment and there is enough room at the shifter location to go back a quarter inch, so the real question has to do with the motor mounts--will they allow for another quarter inch travel toward the back of the engine compartment? Anyone know for sure? Dan Eiland 1974 JH 15069 2.2L with Ford T5 5 speed Attachment: Shroud1.jpg (Downloaded 118 times)
|
||||||||||||||
| |||||||||||||||
| Posted: 11-20-2007 02:48 pm |
|
2nd Post |
|
Jensen Healey Super Moderator 
|
The shroud is the non-stock part here, right? It wasn't engineered for use with A/C which few JHs have. Modify it to suit. Kurt
|
|||||||||||||
| ||||||||||||||
| Posted: 11-21-2007 02:28 pm |
|
3rd Post |
|
Brett Gibson JH5 20497 Member
|
Seem's like the crankshaft pulley is the issue here, why not get a GT or JH5 crank pulley and use that, no way are they as long as the one you have stuck on the front. Or as suggested, mod. or pull the shroud, with electric fans you wont need it. Brett
|
||||||||||||||
| |||||||||||||||
| Posted: 11-21-2007 08:06 pm |
|
4th Post |
|
Dan Eiland Member
|
The JH uses a different A/C setup than the GT. I have tried to locate a GT A/C system but no one will sell me the parts. The parts that are on my car are correct for the JH. I suspect I just need to move the engine back a little. The JH requires the longer crank pulley to align the belt correctly with the compressor. I have three different pullies and the one on there is the only one that aligns the belt. I can always cut the lip off the shroud but I don't know if that would weaken the shroud and cause vibration. I'll look at this over the weekend and decide what route to take to correct this issue.
|
|||||||||||||
| ||||||||||||||
| Current time is 07:49 pm | |
| > Jensen Healey & Jensen GT Tech > Cooling > Fitting Radiator & Shroud with A/C System | Top |
