Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher Page:    1  2  Next Page Last Page  
New Topic Reply Printer Friendly
FUEL PUMP  Rating:  Rating
AuthorPost
 Posted: 05-10-2007 04:42 am
  PM Quote Reply
1st Post
Ian Brooks
Member
 

Joined: 05-16-2006
Location:  
Posts: 11
Status: 
Offline
Bought a rolling chassis & will be doing a total restore with the 2.2 upgrade & the toyota 5 speed.Was wandering what fuel pump would be the best one to get .Have the dellorto 45,s.if that helps.Are there some that are more reliable than other,s.Thanks ,Ian

Back To Top PM Quote Reply  

 Posted: 05-10-2007 02:30 pm
  PM Quote Reply
2nd Post
Judson Manning
Member


Joined: 03-14-2005
Location: Atlanta, Georgia USA
Posts: 406
Status: 
Offline
Ian,

After the cheap pump I bought 10 years ago from Autozone finally died last month, I upgraded to a Holly 'red' fuel pump available at most hot-rod shops.  I'll post some pics of the pump installation, pressure regulator and braided lines later.  This is a very similar set-up to Ron Earp's ITS car and can be considered somewhat 'overkill' as my old pump did just fine during in my limited racing adventures.

The basic upgrade from the original pump is a solid-state version that eliminates the troublesome points.  Personally, I went through 3 Lucas pumps and refuse to try them again, others have had fantastic luck. 

Generally speaking, you can adapt virtually any off-the-shelf pump designed for a mid-70s MGB to work with JH (that's how I ended-up with the above mentioned Autozone pump when Lucas#3 failed).  The only spec you need to keep in mind is fuel pressure should be 1-4psi.

Judson

Back To Top PM Quote Reply

 Posted: 05-10-2007 02:44 pm
  PM Quote Reply
3rd Post
Ian Brooks
Member
 

Joined: 05-16-2006
Location:  
Posts: 11
Status: 
Offline
Thanks for the reply Judson,would any more than 4psi start blowing seals ,flooding or something.Ian

Back To Top PM Quote Reply  

 Posted: 05-10-2007 04:53 pm
  PM Quote Reply
4th Post
Greg Fletcher
Administrator


Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 430
Status: 
Offline
2.5 - 3 pounds is recommended on Strombergs and Dellortos. The replacement SU pump with electronic head is a cool unit.

Back To Top PM Quote Reply

 Posted: 05-10-2007 05:10 pm
  PM Quote Reply
5th Post
Mitch Ware
Member


Joined: 03-12-2005
Location: Albany, New York USA
Posts: 204
Status: 
Offline
I went the expensive electronic SU fuel pump when I restored my car. It crapped out after two years.

 

Mitch Ware

#19670

Back To Top PM Quote Reply  

 Posted: 05-10-2007 05:19 pm
  PM Quote Reply
6th Post
Greg Fletcher
Administrator


Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 430
Status: 
Offline
That's too bad, I've had good luck with the electronic ones. Did you try to repair the unit or know what caused the failure?

Back To Top PM Quote Reply

 Posted: 05-10-2007 07:33 pm
  PM Quote Reply
7th Post
Mitch Ware
Member


Joined: 03-12-2005
Location: Albany, New York USA
Posts: 204
Status: 
Offline
Not sure what caused the failure. The symptom wasn't that it didn't pump at all, it just didn't pump very much. The car would idle all day long, but try and drive it and it would starve for fuel after about a mile. I could push the clutch in and coast, this would allow the pump to catch up, then I could drive another mile.

I do have an inline filter both before and after the fuel pump, and the filter was not getting plugged up with debris, so I didn't think debris was the problem. I think I still have the pump in my garage somewhere. I replaced it with the non-electronic SU and it has been working fine for two years.

 

Mitch Ware

#19670

Back To Top PM Quote Reply  

 Posted: 05-10-2007 10:50 pm
  PM Quote Reply
8th Post
Scott Robinson
Member
 

Joined: 03-22-2005
Location: Libertyville, Illinois USA
Posts: 30
Status: 
Offline
They don't get mentioned on here often, but I have five + years of trouble free road and track usage on (and can recommend) a Carter (universal model) that offers the ideal high volume flow at 2.5 -3 psi. Only thing it doesn't do is click!

 

Back To Top PM Quote Reply

 Posted: 05-14-2007 08:59 pm
  PM Quote Reply
9th Post
j23mau
Member


Joined: 03-13-2005
Location: Monmouth, Illinois USA
Posts: 33
Status: 
Offline
What is the model number scott?  I need to replace one and don't have the original now anyways so staying true to form is no big deal to me.

Thanks----Jeremy

Back To Top PM Quote Reply  

 Posted: 05-16-2007 04:42 am
  PM Quote Reply
10th Post
Scott Robinson
Member
 

Joined: 03-22-2005
Location: Libertyville, Illinois USA
Posts: 30
Status: 
Offline
The Carter pump I have is P/N 152875. Can't find the paperwork, but that's what the label says.

Scott

Back To Top PM Quote Reply

 Posted: 05-16-2007 04:04 pm
  PM Quote Reply
11th Post
Judson Manning
Member


Joined: 03-14-2005
Location: Atlanta, Georgia USA
Posts: 406
Status: 
Offline
Holley Fuel Pump installation pics.  I still need to install and plumb a 'real' fuel filter in place of the glass filter and rubber lines.  Another project for another day...

Attachment: FuelPump1.jpg (Downloaded 73 times)

Last edited on 05-16-2007 04:15 pm by Judson Manning

Back To Top PM Quote Reply  

 Posted: 05-16-2007 04:13 pm
  PM Quote Reply
12th Post
Judson Manning
Member


Joined: 03-14-2005
Location: Atlanta, Georgia USA
Posts: 406
Status: 
Offline
View of engine compartment showing fuel pressure regulator (bottom of screen) and fuel pressure gauge.  Regulator is set at 2-3psi as the Holley 'red' pump is factory set at 7psi and tends to overwhelm the floats and floods the engine.  Hard tubing piped directly to the regulator and AN6 braided line to feed the carburators.

Attachment: FuelPump2.jpg (Downloaded 77 times)

Back To Top PM Quote Reply

 Posted: 05-16-2007 06:45 pm
  PM Quote Reply
13th Post
j23mau
Member


Joined: 03-13-2005
Location: Monmouth, Illinois USA
Posts: 33
Status: 
Offline
Judson,

What is the reason for the fuel line going into the air filters?  My guess is that if you use the original fuel pump or similar you may not need it.  But I will be putting Dells on soon and the more information I have the better.

Thanks Jeremy

Back To Top PM Quote Reply  

 Posted: 05-16-2007 08:20 pm
  PM Quote Reply
14th Post
Judson Manning
Member


Joined: 03-14-2005
Location: Atlanta, Georgia USA
Posts: 406
Status: 
Offline
Jeremy,

The fuel line is not routed to the air-filters.  Yes, there are a myriad of braided hoses in my engine bay, but that is the crankcase ventillation hose going to the air-filters.  That line comes from the windshield wiper fluid resivoir which was converted to a catch-can.

The fuel line can be seen at the bottom of the picture attaching to the pressure gauge, then to the pressure regulator.  What is not visible is the hard line that is plumbed to the bottom of the regulator going back to the pump. 

As I mentioned in my initial posting this is somewhat of an 'overkill' solution.  The only major difference between using the Holley pump and a Lucas-type pump is the need for the regulator.  All the hard & braided lines are there primarly for safety when I go racing.  The technical & safety inspectors tend not to trust British cars, much less 30 year-old plumbing.

Judson

Last edited on 05-16-2007 08:25 pm by Judson Manning

Back To Top PM Quote Reply

 Posted: 05-16-2007 08:41 pm
  PM Quote Reply
15th Post
Greg Fletcher
Administrator


Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 430
Status: 
Offline
I think this was the last guy that routed his fuel line to the air filters (or maybe it was the fuel line to the distributor, I can't remember now)-

Back To Top PM Quote Reply  

 Posted: 05-17-2007 04:17 am
  PM Quote Reply
16th Post
Jensen Healey
Super Moderator


Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
Judson, very sorry to see your car in flames. Next time run the heater hose to the air filters.

Back To Top PM Quote Reply

 Posted: 05-17-2007 02:52 pm
  PM Quote Reply
17th Post
Judson Manning
Member


Joined: 03-14-2005
Location: Atlanta, Georgia USA
Posts: 406
Status: 
Offline
ROTFLMAO!

Better yet, I was thinking of routing the fuel pump through the Halon fire suppression system so it sprayed raw fuel ON the engine and INTO the passanger compartment when activated!

Back To Top PM Quote Reply  

 Posted: 05-24-2007 11:48 pm
  PM Quote Reply
18th Post
timeforwalkies
Member
 

Joined: 05-24-2006
Location:  
Posts: 81
Status: 
Offline
Talk about routing, check this out.  This car was for sale on Ebay two weeks ago.  Any thoughts?
I did look at this car and while sweet in the photos......well, I didn't buy it.
Not that it was bad, just to much bling and an effort to remove.

Attachment: JH FUEL SET UP.JPG (Downloaded 134 times)

Back To Top PM Quote Reply

 Posted: 05-25-2007 01:22 am
  PM Quote Reply
19th Post
Joel
Member
 

Joined: 07-01-2005
Location: San Diego, USA
Posts: 184
Status: 
Offline
i saw that too!  what the heck?  just what i want - my fuel pump exposed to the elements and being hit!

is that a stock rear end?

Last edited on 05-25-2007 01:23 am by Joel

Back To Top PM Quote Reply  

 Posted: 05-25-2007 01:31 am
  PM Quote Reply
20th Post
Greg Fletcher
Administrator


Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 430
Status: 
Offline
I think the idea is- you get rear-ended, fuel sprays all over the place, lights up in a manner similar to the photo above, make insurance claim and buy electric car.

Back To Top PM Quote Reply

Current time is 03:08 am Page:    1  2  Next Page Last Page    
> Jensen Healey & Jensen GT Tech > Engine & Transmission > FUEL PUMP Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems