| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Engine break-in procedures & break-in oils |
| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Engine break-in procedures & break-in oils |
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Engine break-in procedures & break-in oils | Rating: 
|
| Author | Post |
|---|
| Posted: 03-11-2007 01:23 am |
|
1st Post |
|
Dan Eiland Member
|
I'm working on reassembling my engine this week and was wondering if there are any special break-in procedures I should follow and if I should use any special oil to break-in the engine once it has been reassembled?
|
||||||||||||||
| |||||||||||||||
| Posted: 03-11-2007 08:09 pm |
|
2nd Post |
|
Jon Plowe Member
|
As it's a Lotus unit you need a special type that won't show up on your garage floor!!
|
|||||||||||||
| ||||||||||||||
| Posted: 03-12-2007 12:53 am |
|
3rd Post |
|
Dan Eiland Member
|
Show me a LBC and I'll show you an oil spot! Seriously, I just purchased Castrol GTX High Mileage SAE 20W50 motor oil for the assembly process and I'll use the same in the engine as per Greg's input. I am also changing over to the newer style cam carriers, thanks to Garry Kemp who supplied mine and Joe Huffaker's. I finished the auxiliary housing rebuild and set it aside and today I have been working on the head. Just finished changing all the old valve springs to the DMS competition springs and I'm getting ready to move my 104 cams over to the new cam carriers. Next will be to set all the valves. I have some shims but I don't know whether they are the correct sizes for the new cams. I'll install the cams, then dry assemble the head and cam carriers so I can check clearances, then I should have a good idea as to what size shims I will need for each valve. I'll check back in a little while to see if anyone has any input.
|
||||||||||||||
| |||||||||||||||
| Posted: 03-20-2007 03:35 am |
|
4th Post |
|
Dan Eiland Member
|
I was reading on another site I belong to about breaking in a newly rebuilt engine and they were recommending using the Castrol 30W for the first 500 miles and then change to the Castrol 20W50. Anyone have any thoughts on the subject?
|
|||||||||||||
| ||||||||||||||
| Posted: 03-20-2007 04:52 pm |
|
5th Post |
|
Jensen Healey Super Moderator 
|
Just run 20-50. How is it going to hurt the engine? Are your tolerances are so tight that hot 50wt can't flow? If you find that your hot idle oil pressure is 70 psi then use a thinner oil.
|
||||||||||||||
| |||||||||||||||
| Posted: 03-20-2007 08:38 pm |
|
6th Post |
|
smcmanus Member 
|
Dan A thought: You could check the clearances with the valve springs off while standing comfortably next to your work bench. Install the cam carriers and hold the valve up with your finger and measure the gap to see what size shims you'll need. Of course things may change slightly with torque and sealant, but it would be nice to know if you are in the ballpark before you torque the head down. Have a nice day Steve
|
|||||||||||||
| ||||||||||||||
| Current time is 06:40 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Engine break-in procedures & break-in oils | Top |
