| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Driveshaft flange to differential torque? |
| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Driveshaft flange to differential torque? |
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Driveshaft flange to differential torque? | Rate Topic |
| Author | Post |
|---|
| Posted: 11-20-2023 07:18 pm |
|
1st Post |
|
JH12947 Member
|
I've searched around and checked the manuals, but haven't been able to find any spec for the differential flange to driveshaft torque for the 4 attaching bolts on the 4-speed. If anyone has it, let me know- Thanks, Corey
|
||||||||||||||
| |||||||||||||||
| Posted: 11-21-2023 02:13 am |
|
2nd Post |
|
redracer Member
|
Assuming the later, larger flanges that use the 3/8" X 24 threads/inch, standard torque would be 44 ft-lbs for a grade 5 bolt. 40 would probably be all as there is very little tension or compression of the bolts
|
|||||||||||||
| ||||||||||||||
| Posted: 11-21-2023 02:45 am |
|
3rd Post |
|
JH12947 Member
|
Thanks for the reply. The bolts are on a 1973 and are 5/16", if that makes a difference.
|
||||||||||||||
| |||||||||||||||
| Posted: 11-21-2023 12:48 pm |
|
4th Post |
|
redracer Member
|
Sent a "private message" chart so you could print it: https://m.media-amazon.com/images/I/81HOHszn-zS.jpg The one I have used for years came from the back of a Snap-On catalog
|
|||||||||||||
| ||||||||||||||
| Posted: 11-21-2023 08:36 pm |
|
5th Post |
|
DonBurns Member
|
I think the drive shaft flanges use those compressed out of round lock nuts, don’t they? I’ve never worried about the torque on those.
|
||||||||||||||
| |||||||||||||||
| Posted: 11-21-2023 09:09 pm |
|
6th Post |
|
redracer Member
|
So, according to the torque chart for grade 5, fine pitch(24 threads/inch) for a 5/16" diameter bolt, that would be 22lbs-ft
|
|||||||||||||
| ||||||||||||||
| Current time is 05:43 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Driveshaft flange to differential torque? | Top |
