| Moderated by: Greg Fletcher | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
redracer Member
|
When installing a new clutch assembly, check the two pins that engage the throw out bearing for signs of wear on the front surface that rubs against the slot in the bearing. Using a chisel/punch/whatever, rotate the two pins about 90 degrees to essentially give you a new surface' If you have to loosen the pins, just tack weld them in the new position. Attachment: J-H clutch lever pin rotation small.jpg (Downloaded 24 times) |
|||||||||
|
redracer Member
|
pins to be rotated Attachment: J-H clutch lever pin rotation.jpg2 small.jpg (Downloaded 24 times) |
|||||||||
|
redracer Member
|
"new" position Attachment: J-H clutch lever pin rotation.jpg2.jpg3 small.jpg (Downloaded 25 times) |
|||||||||