| ||||
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Frequency Range/Measurement for Warned Up Blue Timing Belts? |
Moderated by: Greg Fletcher |
|
Frequency Range/Measurement for Warned Up Blue Timing Belts? | Rate Topic |
Author | Post |
---|
Posted: 05-20-2022 05:04 am |
|
1st Post |
WhatsUpDOHC Member
|
Hello everyone! 11214 is on the road. I installed a new blue Gates timing belt (from JHPS) and used the Gates app to set it to a consistent 105 Hz. I also replaced the tensioner bearings (also from the JHPS). I read here that the tension/readings will go up when the belt is warmed up so I measured it and it came out at 135 Hz. Does anyone know the acceptable range when hot? I don't hear any whining or anything making me think that it's too tight. I *may* be a bit cautious as this is the first timing belt that I've installed. Also, does anyone have any pictures of a Gates blue belt that's been run for a while? I just want to see what the wear looks like on a known good belt to compare with mine Thank you, Mark
|
||||||||||||||
|
Posted: 05-20-2022 03:20 pm |
|
2nd Post |
WhatsUpDOHC Member
|
I see that Tim E. mentions 125Hz for a black belt in this thread: http://www.jensenhealey.com/forums/view_topic.php?id=2253&forum_id=2
|
|||||||||||||
|
Posted: 05-22-2022 02:47 am |
|
3rd Post |
Esprit2 Member
|
But the black belt tension does not apply to the Blue belt. The Blue belt is thicker, stiffer, heavier... all things that will affect frequency response. Tim
|
||||||||||||||
|
Current time is 05:08 pm | |
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Frequency Range/Measurement for Warned Up Blue Timing Belts? | Top |