| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Rear oil seal (Trans) | Rate Topic |
| Author | Post |
|---|
| Posted: 08-17-2005 06:39 pm |
|
1st Post |
|
Rory Clark Member
|
My 73" JH is up on the stands waiting for my Brake servo assy to be returned from the Rebuilder in Ohio. Since I have the time I am replacing the exaust (from Delta) and I have noticed that the Oil seal has a small leak (something close to Niagra Falls) I guess it is time....So, How difficult is it to change the rear oil seal on the Trans? What are the steps? Rory 73' J-H #13218
|
||||||||||||||
| |||||||||||||||
| Posted: 08-17-2005 11:57 pm |
|
2nd Post |
|
Joseph Mazurk Member
|
Hi Rory, First drain the tranny using a 26mm box wrench on the plug at the bottom and use the same wrench for the fill plug. Buy some new fibre washers and apply them on the fill and drain plugs. Use 20/50 motor oil and it usually takes about 2 and 1/2 quarts. To fill the trans I use a hand pump , sorta like a hyperdermic needle,with a rubber hose attached to it and get under the car and pump it in. When it starts to drip out of the fill hole you have enough in there. Some people attach the hose into the fill hole and run it in the area near the battery and fill from the top. Either way its a pain but once completed you know its done right. Good luck! Joseph Mazurk Chicago, IL
|
|||||||||||||
| ||||||||||||||
| Posted: 08-18-2005 12:04 am |
|
3rd Post |
|
Joseph Mazurk Member
|
Duh, I forgot about getting the trans seal off. Its fairly easy I use a screwdriver and pivot the screwdriver on the rear trans shaft. I work the screwdriver around till the seal start to come out. Clean out any debris you find where the old seal was fitted.Once out, I apply some oil to the outside of the new trans seal so it will easily slid in and lightly hammer the seal in. Finesse vs. power obtains the best results. Joseph Mazurk Chicago, IL
|
||||||||||||||
| |||||||||||||||
| Posted: 08-18-2005 04:14 pm |
|
4th Post |
|
Rory Clark Member
|
Thanks Joseph. Just wanted to make sure that I did not need to do a major R & R on the trans. I have replaced the trans fluid when I first started the restore last August so.. I have the proper oil filler. What part of Chicago you from. I was born raised in Chicago Heights/Park Forest area. (far South side) Rory
|
|||||||||||||
| ||||||||||||||
| Posted: 08-18-2005 04:14 pm |
|
5th Post |
|
Rory Clark Member
|
Thanks Joseph. Just wanted to make sure that I did not need to do a major R & R on the trans. I have replaced the trans fluid when I first started the restore last August so.. I have the proper oil filler. What part of Chicago you from. I was born raised in Chicago Heights/Park Forest area. (far South side) Rory
|
||||||||||||||
| |||||||||||||||
| Current time is 08:09 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Rear oil seal (Trans) | Top |
