| Moderated by: Greg Fletcher | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Steve Duncan Member
|
Anyone know the inside diameter of the hoses that go to and from the oil cooler? |
|||||||||
|
redracer Member
|
without actually cutting one open, the connectors coming out of the hose are 1/2' while the short fittings to the sandwich are 9/16". hope this may help, bruce |
|||||||||
|
Steve Duncan Member
|
Thanks, but I'm hoping someone has cut one open so I can get an accurate measurement . I am planning on splicing in a preluber and would like to get the fittings in advance. |
|||||||||
|
Steve Duncan Member
|
I can confirm (through cutting into two separate junked sets) that there are at least two possible IDs. 1/2" and 5/8" |
|||||||||