Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Cam belt tensioner bolt stripped

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Cam belt tensioner bolt stripped  Rating:  Rating
AuthorPost
 Posted: 04-08-2015 04:12 am
  PM Quote Reply
1st Post
CoryB
Member
 

Joined: 01-25-2013
Location: Stanwood, Washington USA
Posts: 10
Status: 
Offline
 While putting the front of the engine back together, I discovered that the bolt that passes through the tensioner adjuster is stripped.  The aluminum threads in the engine are gone.  The bolt itself doesn't look too bad.  It always felt a little flakey to me, but has always tightened up fine before.  Not so lucky this time.

Has anyone experienced this and (more importantly)....what to do now?  Helicoil?  It there enough meat left in the block to go oversize?  All suggestions welcome.

Thanks.
Back To Top PM Quote Reply  

 Posted: 04-19-2015 09:25 am
  PM Quote Reply
2nd Post
Barthol
Member
 

Joined: 10-31-2013
Location: Denmark
Posts: 67
Status: 
Offline
 Hi I had the same issue on my 79 engine. I changed to the semi automatic tensioner which uses two other holes.

I guess that if you have to repair the thread it must be 100% parallel with all other axles which for seemed impossible to do in free hand.

There is some explanations in my thread ( Blue smoke )

BR
Barthol
Back To Top PM Quote Reply

 Posted: 04-19-2015 09:26 am
  PM Quote Reply
3rd Post
Barthol
Member
 

Joined: 10-31-2013
Location: Denmark
Posts: 67
Status: 
Offline
 sorry thread is "renovated engine burning oil"

BR
Barthol
Back To Top PM Quote Reply  

 Posted: 04-20-2015 05:50 am
  PM Quote Reply
4th Post
Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
 I have not had this experience but seeing you have had no input on your problem the way I would go would be a heli-coil, you end up using the same hole which is aligned for the bearing and also the same size bolt.

Hope it works for you.
Brett
Back To Top PM Quote Reply

 Posted: 04-25-2015 01:47 pm
  PM Quote Reply
5th Post
Jensenman
Member
 

Joined: 04-14-2005
Location: Columbia, South Carolina USA
Posts: 156
Status: 
Offline
 I would Helicoil it back to the stock size, then use a stud and nut instead of a bolt. Aluminum is soft and not really meant to have bolts installed and removed several times.
Back To Top PM Quote Reply  

Current time is 03:43 am  
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Cam belt tensioner bolt stripped Top


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems