| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Clutch Throwout-Bearing Pivot | Rate Topic |
| Author | Post |
|---|
| Posted: 01-25-2012 07:55 pm |
|
1st Post |
|
Paul Koehler Member 
|
Do the 4 speed and 5 speed transmissions both use the same throwout-bearing pivot? Attachment: JH clutch throwout bearing pivot.jpg (Downloaded 122 times)
|
||||||||||||||
| |||||||||||||||
| Posted: 02-09-2012 07:54 pm |
|
2nd Post |
|
Jensen Healey Super Moderator 
|
Hi Paul, I measured the 5 speed pivot from the inside of the bellhousing to the top of the ball on the pivot at 2.050". Perhaps a machinist could modify your 4 speed pivot to fit if needed. Kurt
|
|||||||||||||
| ||||||||||||||
| Posted: 02-09-2012 08:32 pm |
|
3rd Post |
|
Paul Koehler Member
|
Thanks Kurt-that is exactly the info I needed to modify the 4 speed pivot
|
||||||||||||||
| |||||||||||||||
| Posted: 02-09-2012 10:04 pm |
|
4th Post |
|
Jensen Healey Super Moderator
|
Sorry it took so long Paul. Are the rest of the parts the same for either trans? Release lever, throwout bearing etc? Kurt
|
|||||||||||||
| ||||||||||||||
| Posted: 02-10-2012 05:23 am |
|
5th Post |
|
Paul Koehler Member
|
The release lever appears to be the same; the throwout bearing is different. I have not seen it yet - it is on order and you have to make a choice of either 4 or 5 speed speedo cable, so I guess that is different. Bell housing is unique to the Getrag unit, but the clutch, pressure plate and pilot bearing can be used in either set-up. Also, as has been mention in earlier discourses, the tranny mount is different and in another location. PK
|
||||||||||||||
| |||||||||||||||
| Current time is 05:59 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Clutch Throwout-Bearing Pivot | Top |
