| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| 5 spd Shifter removal help needed | Rate Topic |
| Author | Post |
|---|
| Posted: 03-21-2011 02:32 am |
|
1st Post |
|
pbahr Member 
|
Hi guys, I'm in process of rebuilding several of the 5spd Shifter assemblies. Another JH owner is interested in joining the group, but he will need to remove the Shifter assy without removing the Tranny. I don't know how to do this, or if it is easy or difficult. I have JH Service Buletin # 16, which states: "Remove the gear change assembly from the transmission . (Refer to five-speed transmission Workshop Manual Supplement.)" Certainly implies it can be done without Tranny removal. I don't have that paper. Any help would be appreciated. Send me a direct email: peteb01@comcast.net Thanks, Pete
|
||||||||||||||
| |||||||||||||||
| Posted: 03-21-2011 02:24 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Pete, Yes the shifter can be removed with out much trouble at all, I don’t have the diagram in front of me but if memory serves you pull the consul to get at the rear mount bolt, remove the trunion clip that retains the pins, carefully you don’t want to break it or over flex it, remove one or both pins, then the two bolts that hold it to the trans them fish it out, if more people new how easy it was you'd be flooded with work. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 03-21-2011 04:54 pm |
|
3rd Post |
|
pbahr Member
|
Thanks Brett. Please do not tell anyone how easy it is, as I'm already flooded with work ! ! ! ! YELODOG
|
||||||||||||||
| |||||||||||||||
| Posted: 03-26-2011 02:44 am |
|
4th Post |
|
rossjfox Member
|
Having just done this with kudos to Jim DeClerck for directions, here's how I did it... 1. Remove the knob and locking nut on the shifter. 2. Set the parking brake and block the rear wheels to prevent rolling. Jack up the front high, install jack stands on both sides as wide on the frame as practical. Same on the rear. Get it high enough for you to get under the car and use tools. Plug in the drop light and place it under the car. 3. Using a socket wrench remove the 4 bolts/nuts holding the drive shaft to the rear flange of the transmission. This will allow easier access to the 2 bolts securing the shifter assembly to the rear of the transmission body. 4. Gently twist open, rotate and slide the sleeve that fits over the center of the trunnion unit. Remove the .235" diameter pin that secures the trunnion to the end of the transmission shaft. It should slide out easily with an appropriately sized punch. 5. Remove the nut at the rear of the shifter body that connects to the rubber vibration damping mount. 6. Remove the 2 bolts and at the front of the shifter assembly that attach it to the rear of the transmission body. The entire linkage should now be removable down below the car. Ross
|
|||||||||||||
| ||||||||||||||
| Current time is 03:21 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > 5 spd Shifter removal help needed | Top |
