| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Cam cover washers from the club store | Rating: 
|
| Author | Post |
|---|
| Posted: 12-16-2009 01:15 am |
|
1st Post |
|
Jensen Healey Super Moderator 
|
What's the best way to install the cam cover washers from the club store? I don't want to damage the rubber part by tightening the bolt head down onto it so I'm thinking of using standard washers over them. I am also concerned that the rubber won't seal to the cam cover. Should I use a rubber washer under it? Maybe a dab of Hylomar would be best. Kurt
|
||||||||||||||
| |||||||||||||||
| Posted: 12-16-2009 02:07 pm |
|
2nd Post |
|
Brett Gibson JH5 20497 Member
|
Kurt, I have used these washers both from the store and McMaster-Carr, what works for me is having the washer go against the valve cover then a plain washer, no issue's, plus they can be reused up to a point. Brett
|
|||||||||||||
| ||||||||||||||
| Posted: 12-16-2009 04:01 pm |
|
3rd Post |
|
Jensen Healey Super Moderator
|
Thanks Brett, I'm concerned that the surface of the re-painted (wrinkle finish) valve cover isn't smooth enough for the small rubber surface of the washers. I'm just going to use the Seloc washers since I never had a problem with them before. Kurt
|
||||||||||||||
| |||||||||||||||
| Current time is 10:03 pm | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > Cam cover washers from the club store | Top |
