| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| tranny circlip/snapring | Rating: 
|
| Author | Post |
|---|
| Posted: 07-02-2009 02:39 am |
|
1st Post |
|
Paul Koehler Member 
|
I've already busted two different set of snap ring pliers, trying to get the internal circlip off the rear-end of my 4-speed. I'm getting a bit frustrated, but am almost ready to drop the big $ for Snap-On, Mac or non POS brand. Anybody have experience removing that bad-boy snap-ring. My ultimate goal is to replace to transmission seal. It is not exactly pissing out oil, but every time I chech the floor, I can see where it has "marked its territory", and seeing how it is such a "pleasure" to add more oil, I thought it time to change the seal.
|
||||||||||||||
| |||||||||||||||
| Posted: 07-02-2009 02:42 am |
|
2nd Post |
|
JodyKerr Member 
|
Steve and I just did the same thing on his JH 4-speed. The trick is to get the snap ring started and use a coulpe small screw drivers as shims to keep it from dropping back into the track. It requires a little patience, but isn't that hard. We did it with two small screwdrivers and a set of ring pliers from Harbor Freight.
|
|||||||||||||
| ||||||||||||||
| Current time is 09:46 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > tranny circlip/snapring | Top |
