| ||||
Moderated by: Greg Fletcher |
|
Cam removal | Rate Topic |
Author | Post |
---|
Posted: 04-21-2009 07:48 pm |
|
1st Post |
andrewo Member
|
I am in the process of stripping down a spare engine that I picked up, and I want to actually remove the cams. I have looked at the diagrams and read the service manual, but can't seem to find a good way to remove the rear cover and O ring to get to the retaining bolt. The two bolts that hold the cover on are out, but the cover won't budge, and I am a little afraid of applying much force to aluminum parts. Has anyone found a good trick for this? Thanks in advance.
|
||||||||||||||
|
Posted: 04-22-2009 12:09 am |
|
2nd Post |
Judson Manning Member
|
Once the two short bolts are out you can rotate the retaining plate to expose the ears. It is a tight fit and there is an o-ring adding resistance but some gentle tapping and alternating prying will get the cover off. You can always tap on the cam nose and partially push the cam out the back for additional leverage.
|
|||||||||||||
|
Posted: 04-22-2009 05:26 pm |
|
3rd Post |
andrewo Member
|
Thanks. Worked like a champ. I couldn't get the cover to rotate, but a couple of taps on the front of the camshaft pushed the rear cover off enough to create a gap that I could work with.
|
||||||||||||||
|
Current time is 08:04 am | |
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Cam removal | Top |