| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| O/D for the 4 speed | Rating: 
|
| Author | Post |
|---|
| Posted: 03-25-2009 08:33 pm |
|
1st Post |
|
dwalls1 Member
|
I didn't search the archives on this and I'll bet it's been covered, but here goes anyway. I'm thinking of spending some tax refund money on the J-type O/D unit offered on E-bay by some folks in New Zealand. With a discount offered by E-bay it would cost $875.00 including shipping. Would appreciate any thoughts, comments on this. Also how big a chore would it be to install such a unit. Thanks in advance. Dale
|
||||||||||||||
| |||||||||||||||
| Posted: 03-27-2009 04:22 am |
|
2nd Post |
|
Jensen Healey Super Moderator 
|
It has come up in the past. IIRC you need a mainshaft from a Sunbeam/Hillman that came with the overdrive.
|
|||||||||||||
| ||||||||||||||
| Posted: 03-27-2009 08:30 pm |
|
3rd Post |
|
dwalls1 Member
|
Thanks for the response. If the mainshaft needs to be replaced then I assume the tranny must come out. I was perusing the service manual last night and it semed to indicate the tranny could be removed without the clutch and bell housing. Am I halucinating?
|
||||||||||||||
| |||||||||||||||
| Posted: 03-28-2009 08:51 pm |
|
4th Post |
|
Jensenman Member
|
That is correct, the transmission can be removed without removing the bellhousing.
|
|||||||||||||
| ||||||||||||||
| Current time is 05:56 am | |
| > Jensen Healey & Jensen GT Tech > Engine & Transmission > O/D for the 4 speed | Top |
