| ||||
> Jensen Healey & Jensen GT Tech > VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database |
Moderated by: Greg Fletcher | Page: ... 8 9 10 11 12 13 14 15 16 17 18 |
|
Jensen Healey & Jensen GT VIN Database | Rating: |
Author | Post |
---|
Posted: 04-26-2015 08:13 pm |
|
241st Post |
timeforwalkies Member
|
JH #19642 Engine No. B74 12 10 579 Purchased May 2015 in Sebastapol, CaThis car is no more. It burned in the Santa Rosa fire in Oct, of 2017 along with "Goldmember" Now in Santa Rosa, ca Donor car. Engine turns freely, car rolls, but is as much rust as good steel. 5 speed car with 75,000 original miles. Previous owner removed carbs 28 years ago to rebuild, and car has sat since. More than likely to be used as spare parts for 24 Hours of Lemons car "Goldmember" #907 Go to Old Crows Racing on Facebook. Not registered since 1988 or running. Last edited on 06-10-2019 05:32 am by timeforwalkies |
||||||||||||||
|
Posted: 07-31-2015 06:21 am |
|
242nd Post |
answerman Member
|
JH #12281, or most of her, is in my driveway on my trailer. 1973 JH Mk I. Will be scrapped after removal of the few good parts. No engine or transmission (actually there is a transmission in the boot, but I don't believe it actually goes with the car since it looks nothing like the Rootes transmission and has MOWOG stamped on it in a couple of places). Quick research implies that it might be an old MG transmission. I'll look further into that. Anyway, the rest of the car is exceedingly rusty. No floors to speak of, fenders are rusty in the usual spots, the bonnet is actually separated at the front. I was going to make the guy an offer for just the rear bumper (lots of surface rust but otherwise straight, including the stainless panel) and some electrical odds and ends, but decided just to bring the whole car home and remove everything of value, which isn't a whole lot. The dash has one small crack and is otherwise good, the gauges all look good, the headlight pods are ok other than paint (they are the square bottom ones), the original rocker switches and turn signal and wiper switches are there, glovebox is good, and the seats are surprisingly good (just a separated seam on the driver's seat) though they are black and I can't use them in Ms. Jenavieve since she has a tan interior. So, a couple of weekends removing stuff, and then off to the recycling yard she goes. If anyone is looking for Mk I "non-body" and "non-drivetrain" parts, ask since I may have something you can use. Otherwise I'll just hang on to them for now.
|
|||||||||||||
|
Posted: 12-17-2015 03:04 am |
|
243rd Post |
Robert Janca Member
|
1972 MKI VIN# 10792 Is still almost completely rust free and living in the San Francisco, CA East Bay. I bought it a few years back and it already had a Ford 2.8L V6 installed by a previous owner which runs like a top. As a consequence, this early JH is taken out for drives more than once a week. I often drive it every day. I rewired it, built a custom steel dashboard, added Speedwell gauges, installed Fiero seats, LeCarra wheel, new carpeting, custom door panels, aluminum radiator, air dam etc... I have several wonderful old cars, but this one is so much fun to drive and tinker on that it gets plenty of my tinkering and driving time. Last edited on 12-17-2015 03:04 am by Robert Janca |
||||||||||||||
|
Posted: 12-23-2015 09:45 pm |
|
244th Post |
Matthew10571 Member
|
I have 10571 (driver) I can't find the engine # yet. Is has about 43,737, man. Date 11/9/72. My parts car is #14518 (never see the road again). Engine #B73 11 4621, mileage 88937 (188937?), man date 23/11/73. How can you tell if they are a matching #s car?
|
|||||||||||||
|
Posted: 01-06-2016 12:12 am |
|
245th Post |
sscheffel Member
|
JH #17234 Engine: B74 06 7744. Excellent overall condition with engine rebuilt to European specs. located in Windsor CO
|
||||||||||||||
|
Posted: 02-22-2016 12:32 am |
|
246th Post |
Stewbacca Member
|
JH# 16501. Is now running a 202ci Holden 6 with a W50 Toyota 5 speed - according to engineer's report was converted in 1991. The car has been off the road for about 10 years, but just seems to need the clutch hydraulics rebuilt & basic fluid changes. Holden motor runs nicely & has receipts for full reco & some performance mods. Should be back on the road shortly :)
|
|||||||||||||
|
Posted: 05-04-2016 09:51 pm |
|
247th Post |
little red Member
|
1974 JH5 VIN #19029 Engine# B7410-9836 Dellorto 45’S - Getrag 5 speed - Pertronix ignition - 3 core aluminum radiator Front and rear sway bars – Roll bar 26,000 miles after top end rebuild Red with black interior – no rust – paint is good a 20 footer Good running condition – Daily driver over 3000 miles since bought November 27, 2015 Located Fort Myers Florida
|
||||||||||||||
|
Posted: 06-16-2016 05:34 pm |
|
248th Post |
NJ_Brit Member
|
Hi, New Member, and Expat Brit, living in Central NJ. A couple of weeks ago I bought a Yellow 1974 JH. VIN is 14664, Engine No. D907E-0050Y (though the D may be a 0). The plate on the driver's door shows VIN 19742, so I guess that was sourced from a donor car at some point. There is also a ID of BB279 stamped on the upper engine block near the fuel intakes. The car is in good to excellent condition, and is running Dellorto carburetors, which are new to me. Every gauge and light seems to work, save for the clock, but I have not really had chance to look at everything yet. Some surface rust around the wheels, but that's it. I have invoices totalling ~$32,000 going back to 1988, including a full respray in 2006, and a couple of full engine overhauls. She seems to have lived in CO, FL, NY and NJ according to the state registration documents that were included in the paperwork I was given. Attachment: JH Side Smaller.jpg (Downloaded 242 times) Last edited on 06-16-2016 06:18 pm by NJ_Brit |
|||||||||||||
|
Posted: 06-17-2016 06:32 pm |
|
249th Post |
Earthscrew Member
|
Welcome to the group, I can guarantee you will find this site helpful in figuring out the eccentricities of these cars. Myself, I have been become quite good at chasing down the many oil leaks that spring up weekly! Ken
|
||||||||||||||
|
Posted: 06-17-2016 07:15 pm |
|
250th Post |
NJ_Brit Member
|
Ken, Thanks - so far I've only noted some minor spotting, and only after longish drives, once the oil system has got properly warmed up. Certainly a lot better than my Spitfire! Figure I'll chase that down when she needs to have an oil change. Stuart
|
|||||||||||||
|
Posted: 06-17-2016 07:39 pm |
|
251st Post |
answerman Member
|
Q. What does it mean when a Jensen Healey stops leaking oil? A. It's out of oil. Seriously, I don't think there is such a thing as a leak free British car of the era. I belong to the local British car club, and we have a very nice clubhouse/showroom where several members (including myself) park their cars over the winter. It's so funny to see... 30 to 40 British cars, not just LBCs but also Rolls Royces, Morgans, Jaguar saloons, etc. most in gorgeous condition, all shiny and perfect and exotic looking, probably well over a million dollars worth of cars. And EVERY one of them has an oil-soaked sheet of cardboard on the floor underneath the engine. EVERY one.
|
||||||||||||||
|
Posted: 06-17-2016 07:55 pm |
|
252nd Post |
timeforwalkies Member
|
Upgraded my JH to a full 2.2 conversion. I did "have" leaks from the cam towers, but put a proper torque on them and the leaks are gone. Have had a pan under the car for 3 years now and not a drop. Same on our 24 Hours of Lemons race car that just won class at Thunderhill in California. Had to do the towers twice to get the gasket properly seated and now no leaks. Do have a rear seal leak but it's pretty minor. 74 2.2 JH 5 speed.
|
|||||||||||||
|
Posted: 06-18-2016 02:10 pm |
|
253rd Post |
Brett Gibson JH5 20497 Member
|
Time, Service bulletin's don't call for a gasket any longer, as long as the oil passage has the O-ring groove in the tower gasket compound is recommended. Then of course if missing the gasket you then need to shim the valve's as well to compensate. But then again if it don't leak , don't muck with it....... Brett
|
||||||||||||||
|
Posted: 06-18-2016 04:37 pm |
|
254th Post |
timeforwalkies Member
|
Sorry. Was talking about the cover, not the tower itself. Clif
|
|||||||||||||
|
Posted: 06-22-2016 06:32 pm |
|
255th Post |
NJ_Brit Member
|
Still laughing at the image of all those perfectly restored classics sat with the high tech cardboard oil mat solution.
|
||||||||||||||
|
Posted: 06-23-2016 04:22 am |
|
256th Post |
timeforwalkies Member
|
That comment must have been meant for a different thread. It doesn't makes sense here. but curious as to what you are talking about? clif
|
|||||||||||||
|
Posted: 06-23-2016 06:05 am |
|
257th Post |
answerman Member
|
Go back up to my post about 6 up the page... it will all become clear.
|
||||||||||||||
|
Posted: 07-18-2016 06:18 pm |
|
258th Post |
azvat1 Member
|
1974 JH VIN 19343 ENGINE 10218, 5 sp. Getrag gear box, 61,900 miles, Red with tan interior, good condition, purchased from original owner July, 2015, Mikuni carburetors installed by original owner after engine fire in 1989.
|
|||||||||||||
|
Posted: 07-18-2016 07:38 pm |
|
259th Post |
Screenplay Member
|
azvat1; Is yours a JH5? Just curious as I have 19451 which came without badging. I've read where some of the cars in this sequence were badged as JH5s.
|
||||||||||||||
|
Posted: 07-18-2016 07:38 pm |
|
260th Post |
Screenplay Member
|
Last edited on 07-18-2016 07:38 pm by Screenplay |
|||||||||||||
|
Current time is 05:04 am | Page: ... 8 9 10 11 12 13 14 15 16 17 18 |
> Jensen Healey & Jensen GT Tech > VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database | Top |