Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher Page:  First Page Previous Page  ...  8  9  10  11  12  13  14  15  16  17  18  Next Page Last Page  
New Topic Reply Printer Friendly
Jensen Healey & Jensen GT VIN Database  Rating:  Rating
AuthorPost
 Posted: 04-26-2015 08:13 pm
  PM Quote Reply
241st Post
timeforwalkies
Member
 

Joined: 05-24-2006
Location:  
Posts: 81
Status: 
Offline
JH #19642
Engine No. B74 12 10 579
Purchased May 2015 in Sebastapol, CaThis car is no more.  It burned in the Santa Rosa fire in Oct, of 2017 along with "Goldmember"
Now in Santa Rosa, ca
Donor car. Engine turns freely, car rolls, but is as much rust as good steel. 5 speed car with 75,000 original miles. Previous owner removed carbs 28 years ago to rebuild, and car has sat since. More than likely to be used as spare parts for 24 Hours of Lemons car "Goldmember" #907 Go to Old Crows Racing on Facebook.
Not registered since 1988 or running.

Last edited on 06-10-2019 05:32 am by timeforwalkies

Back To Top PM Quote Reply  

 Posted: 07-31-2015 06:21 am
  PM Quote Reply
242nd Post
answerman
Member
 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
JH #12281, or most of her, is in my driveway on my trailer. 1973 JH Mk I. Will be scrapped after removal of the few good parts.

No engine or transmission (actually there is a transmission in the boot, but I don't believe it actually goes with the car since it looks nothing like the Rootes transmission and has MOWOG stamped on it in a couple of places). Quick research implies that it might be an old MG transmission. I'll look further into that.

Anyway, the rest of the car is exceedingly rusty. No floors to speak of, fenders are rusty in the usual spots, the bonnet is actually separated at the front. I was going to make the guy an offer for just the rear bumper (lots of surface rust but otherwise straight, including the stainless panel) and some electrical odds and ends, but decided just to bring the whole car home and remove everything of value, which isn't a whole lot. The dash has one small crack and is otherwise good, the gauges all look good, the headlight pods are ok other than paint (they are the square bottom ones), the original rocker switches and turn signal and wiper switches are there, glovebox is good, and the seats are surprisingly good (just a separated seam on the driver's seat) though they are black and I can't use them in Ms. Jenavieve since she has a tan interior.

So, a couple of weekends removing stuff, and then off to the recycling yard she goes. If anyone is looking for Mk I "non-body" and "non-drivetrain" parts, ask since I may have something you can use. Otherwise I'll just hang on to them for now.

Back To Top PM Quote Reply

 Posted: 12-17-2015 03:04 am
  PM Quote Reply
243rd Post
Robert Janca
Member
 

Joined: 10-19-2012
Location:  
Posts: 21
Status: 
Offline
1972 MKI
VIN# 10792
Is still almost completely rust free and living in the San Francisco, CA East Bay.
I bought it a few years back and it already had a Ford 2.8L V6 installed by a previous owner which runs like a top. As a consequence, this early JH is taken out for drives more than once a week. I often drive it every day.
I rewired it, built a custom steel dashboard, added Speedwell gauges, installed Fiero seats, LeCarra wheel, new carpeting, custom door panels, aluminum radiator, air dam etc...
I have several wonderful old cars, but this one is so much fun to drive and tinker on that it gets plenty of my tinkering and driving time.

Last edited on 12-17-2015 03:04 am by Robert Janca

Back To Top PM Quote Reply  

 Posted: 12-23-2015 09:45 pm
  PM Quote Reply
244th Post
Matthew10571
Member
 

Joined: 12-11-2015
Location:  
Posts: 16
Status: 
Offline
I have 10571 (driver) I can't find the engine # yet. Is has about 43,737, man. Date 11/9/72. My parts car is #14518 (never see the road again).
Engine #B73 11 4621, mileage 88937 (188937?), man date 23/11/73. How can you tell if they are a matching #s car?

Back To Top PM Quote Reply

 Posted: 01-06-2016 12:12 am
  PM Quote Reply
245th Post
sscheffel
Member
 

Joined: 11-04-2015
Location: Windsor, Colorado USA
Posts: 13
Status: 
Offline
JH #17234 Engine: B74 06 7744. Excellent overall condition with engine rebuilt to European specs. located in Windsor CO

Back To Top PM Quote Reply  

 Posted: 02-22-2016 12:32 am
  PM Quote Reply
246th Post
Stewbacca
Member
 

Joined: 02-21-2016
Location:  
Posts: 1
Status: 
Offline
JH# 16501. Is now running a 202ci Holden 6 with a W50 Toyota 5 speed - according to engineer's report was converted in 1991. The car has been off the road for about 10 years, but just seems to need the clutch hydraulics rebuilt & basic fluid changes. Holden motor runs nicely & has receipts for full reco & some performance mods. Should be back on the road shortly :)

Back To Top PM Quote Reply

 Posted: 05-04-2016 09:51 pm
  PM Quote Reply
247th Post
little red
Member
 

Joined: 04-18-2016
Location: Fort Myers, Florida USA
Posts: 20
Status: 
Offline
1974 JH5  VIN #19029  Engine#  B7410-9836
Dellorto 45’S - Getrag  5 speed - Pertronix ignition - 3 core aluminum radiator
Front and rear sway bars – Roll bar
26,000 miles after top end rebuild
Red with black interior – no rust – paint is good a 20 footer
Good running condition – Daily driver over 3000 miles since bought November 27,  2015
Located Fort Myers Florida

Back To Top PM Quote Reply  

 Posted: 06-16-2016 05:34 pm
  PM Quote Reply
248th Post
NJ_Brit
Member


Joined: 06-16-2016
Location: Martinsville, New Jersey USA
Posts: 16
Status: 
Offline
Hi, New Member, and Expat Brit, living in Central NJ.

A couple of weeks ago I bought a Yellow 1974 JH.  VIN is 14664, Engine No. D907E-0050Y (though the D may be a 0).  The plate on the driver's door shows VIN 19742, so I guess that was sourced from a donor car at some point.  There is also a ID of BB279 stamped on the upper engine block near the fuel intakes.

The car is in good to excellent condition, and is running Dellorto carburetors, which are new to me.

Every gauge and light seems to work, save for the clock, but I have not really had chance to look at everything yet.  Some surface rust around the wheels, but that's it.

I have invoices totalling ~$32,000 going back to 1988, including a full respray in 2006, and a couple of full engine overhauls.  She seems to have lived in CO, FL, NY and NJ according to the state registration documents that were included in the paperwork I was given.

Attachment: JH Side Smaller.jpg (Downloaded 242 times)

Last edited on 06-16-2016 06:18 pm by NJ_Brit

Back To Top PM Quote Reply

 Posted: 06-17-2016 06:32 pm
  PM Quote Reply
249th Post
Earthscrew
Member
 

Joined: 08-01-2014
Location:  
Posts: 25
Status: 
Offline
Welcome to the group, I can guarantee you will find this site helpful in figuring out the eccentricities of these cars.

Myself, I have been become quite good at chasing down the many oil leaks that spring up weekly!

Ken

Back To Top PM Quote Reply  

 Posted: 06-17-2016 07:15 pm
  PM Quote Reply
250th Post
NJ_Brit
Member


Joined: 06-16-2016
Location: Martinsville, New Jersey USA
Posts: 16
Status: 
Offline
Ken,

Thanks - so far I've only noted some minor spotting, and only after longish drives, once the oil system has got properly warmed up.  Certainly a lot better than my Spitfire!

Figure I'll chase that down when she needs to have an oil change.



Stuart

Back To Top PM Quote Reply

 Posted: 06-17-2016 07:39 pm
  PM Quote Reply
251st Post
answerman
Member
 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
Q. What does it mean when a Jensen Healey stops leaking oil?

A. It's out of oil.

Seriously, I don't think there is such a thing as a leak free British car of the era. I belong to the local British car club, and we have a very nice clubhouse/showroom where several members (including myself) park their cars over the winter. It's so funny to see... 30 to 40 British cars, not just LBCs but also Rolls Royces, Morgans, Jaguar saloons, etc. most in gorgeous condition, all shiny and perfect and exotic looking, probably well over a million dollars worth of cars. And EVERY one of them has an oil-soaked sheet of cardboard on the floor underneath the engine. EVERY one.

Back To Top PM Quote Reply  

 Posted: 06-17-2016 07:55 pm
  PM Quote Reply
252nd Post
timeforwalkies
Member
 

Joined: 05-24-2006
Location:  
Posts: 81
Status: 
Offline
Upgraded my JH to a full 2.2 conversion.  I did "have" leaks from the cam towers, but put a proper torque on them and the leaks are gone.  Have had a pan under the car for 3 years now and not a drop.  Same on our 24 Hours of Lemons race car that just won class at Thunderhill in California.  Had to do the towers twice to get the gasket properly seated and now no leaks.  Do have a rear seal leak but it's pretty minor.
74 2.2 JH 5 speed. 

Back To Top PM Quote Reply

 Posted: 06-18-2016 02:10 pm
  PM Quote Reply
253rd Post
Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
Time, Service bulletin's don't call for a gasket any longer, as long as the oil passage has the O-ring groove in the tower gasket compound is recommended. Then of course if missing the gasket you then need to shim the valve's as well to compensate. But then again if it don't leak , don't muck with it.......

Brett

Back To Top PM Quote Reply  

 Posted: 06-18-2016 04:37 pm
  PM Quote Reply
254th Post
timeforwalkies
Member
 

Joined: 05-24-2006
Location:  
Posts: 81
Status: 
Offline
Sorry.  Was talking about the cover, not the tower itself.
Clif

Back To Top PM Quote Reply

 Posted: 06-22-2016 06:32 pm
  PM Quote Reply
255th Post
NJ_Brit
Member


Joined: 06-16-2016
Location: Martinsville, New Jersey USA
Posts: 16
Status: 
Offline
Still laughing at the image of all those perfectly restored classics sat with the high tech cardboard oil mat solution.

Back To Top PM Quote Reply  

 Posted: 06-23-2016 04:22 am
  PM Quote Reply
256th Post
timeforwalkies
Member
 

Joined: 05-24-2006
Location:  
Posts: 81
Status: 
Offline
That comment must have been meant for a different thread.  It doesn't makes sense here.  but curious as to what you are talking about?
clif

Back To Top PM Quote Reply

 Posted: 06-23-2016 06:05 am
  PM Quote Reply
257th Post
answerman
Member
 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
Go back up to my post about 6 up the page... it will all become clear.

Back To Top PM Quote Reply  

 Posted: 07-18-2016 06:18 pm
  PM Quote Reply
258th Post
azvat1
Member
 

Joined: 01-21-2016
Location: Scottsdale, Arizona USA
Posts: 6
Status: 
Offline
1974 JH VIN 19343 ENGINE 10218, 5 sp. Getrag gear box, 61,900 miles, Red with tan interior, good condition, purchased from original owner July, 2015, Mikuni carburetors installed by original owner after engine fire in 1989.

Back To Top PM Quote Reply

 Posted: 07-18-2016 07:38 pm
  PM Quote Reply
259th Post
Screenplay
Member
 

Joined: 07-12-2013
Location: San Francisco, California USA
Posts: 124
Status: 
Offline
azvat1; Is yours a JH5? Just curious as I have 19451 which came without badging. I've read where some of the cars in this sequence were badged as JH5s.

Back To Top PM Quote Reply  

 Posted: 07-18-2016 07:38 pm
  PM Quote Reply
260th Post
Screenplay
Member
 

Joined: 07-12-2013
Location: San Francisco, California USA
Posts: 124
Status: 
Offline

Last edited on 07-18-2016 07:38 pm by Screenplay

Back To Top PM Quote Reply

Current time is 03:30 am Page:  First Page Previous Page  ...  8  9  10  11  12  13  14  15  16  17  18  Next Page Last Page    
> Jensen Healey & Jensen GT Tech > VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems