| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Trunk lock | Rate Topic |
| Author | Post |
|---|
| Posted: 10-01-2007 07:38 pm |
|
1st Post |
|
OneBuck Member
|
Just starting a restoration on a 1974 JH. Picked it up a few days ago. Stored for 22 years in a shed north of Palmdale, CA. Trunk is locked with a key broke off in the lock. Any suggestions...besides call a lock smith? Thanks, OneBuck David Gunderson
|
||||||||||||||
| |||||||||||||||
| Posted: 10-01-2007 10:00 pm |
|
2nd Post |
|
Greg Fletcher Administrator 
|
I might try spraying in some Tri-Flow type lubricant and seeing if a pair of needle nose pliers and a jeweler's screwdriver would help.
|
|||||||||||||
| ||||||||||||||
| Posted: 10-12-2007 01:54 pm |
|
3rd Post |
|
jcdean Member
|
Purchase the finest (read that smallest) coping saw blade you can find. Break off the end so that the tooth taper will slide past the key and insert it down into the keyhole next to any part of the key you can get it to fit next to. Give the broken blade enough of a twist to exert pressure on the eky. This will cause half the teeth to bite into the key due to the blades kerf. Pull out slowly. Rinse and repeat and you should have good luck after a pull or two. Joey /|/|/|/|/|/|/|/|/|____ ^ Insert this end first. (Ahhh, where is an ASCII chart when you need one?)
|
||||||||||||||
| |||||||||||||||
| Current time is 03:52 am | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Trunk lock | Top |
