| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Steering bushing | Rate Topic |
| Author | Post |
|---|
| Posted: 10-06-2020 03:30 pm |
|
1st Post |
|
Jagwire64 Member
|
Found what was left of probably the original steering bushing on the floor under the car. Took a bit to figure out what it was. Ordered a replacement but am not sure where it is installed exactly. Read Art DeKneef's install directions: remove u joint, remove column bolts, left out column, install bush. From what i gather it either goes in from the engine firewall side (unbolting the column may not be needed) or it goes in from the interior and you must first remove the lower column mounting bracket (his install doesn't list that step?) Or you don't need to remove the bracket? The shop diagram doesn't show the firewall in relation to the bush and bracket. Thanks.
|
||||||||||||||
| |||||||||||||||
| Posted: 10-06-2020 10:13 pm |
|
2nd Post |
|
Jagwire64 Member
|
I got it figured out. bushing goes in on the engine side. Did find some remnants of a perished rubber isolater/grommet that goes between the firewall cut out and column shroud? Any one have a source or spec for this part? It isn't listed in the shop diagram. I jury rigged some large gasket and put the half piece back in.
|
|||||||||||||
| ||||||||||||||
| Posted: 10-07-2020 02:05 am |
|
3rd Post |
|
redracer Member
|
If you're talking about the firewall bushing for the upper steering shaft as it passes through the firewall, the original was a piece of leather encased in a plastic/nylon outer shell with 2 "nibs" on the outside to fit into holes inside the firewall. DELTA has a nice "neoprene" bushing with the 2 nibs to replace the archaic original, with a small packet of silicone(very necessary to use it.) I would recommend this replacement highly. cheers, bruce
|
||||||||||||||
| |||||||||||||||
| Current time is 04:57 am | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Steering bushing | Top |
