Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
STEERING WHEEL REMOVAL  Rate Topic 
AuthorPost
 Posted: 11-12-2013 08:58 pm
  PM Quote Reply
1st Post
timeforwalkies
Member
 

Joined: 05-24-2006
Location:  
Posts: 81
Status: 
Offline
Easy question.  How do you remove the plate on the steering wheel to access it's mounting?  I need to replace the turn indicator.
Thank you
Clif

Back To Top PM Quote Reply  

 Posted: 11-13-2013 02:02 pm
  PM Quote Reply
2nd Post
Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
Pry it out gently or you may crack the rubber around it, use a bit of silicone to help it along.

 

Back To Top PM Quote Reply

 Posted: 11-14-2013 01:15 am
  PM Quote Reply
3rd Post
timeforwalkies
Member
 

Joined: 05-24-2006
Location:  
Posts: 81
Status: 
Offline
Thanks.  I got it out.  I had done this before and there was already some tearing in the corner, and I have noticed this in other cars.  Seems very few don't have the tears.
I had to install a used turn/wiper unit and I am replacing the wood so both seemed a good thing to do.
But does anybody have a line on that Lucas instrument dimmer?  I think I broke mine trying to get the knob off.  Not the knob, but pot.  The post came out out at the last minute and i can hear some stuff rattling around inside.

Back To Top PM Quote Reply  

 Posted: 11-14-2013 07:57 am
  PM Quote Reply
4th Post
answerman
Member
 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
It's addressed in this thread:

http://www.jensenhealey.com/forums/view_topic.php?id=1111&forum_id=11

Apparently one from a 70s Jag fits, works better, and is easier to find. Personally I just bypassed my dimmer since it didn't work right and it's not like the stock dash lights need dimming anyway.

Back To Top PM Quote Reply

 Posted: 10-10-2016 11:02 am
  PM Quote Reply
5th Post
qwerty
Member


Joined: 10-01-2016
Location: Australia
Posts: 77
Status: 
Offline
For prying the center plate out without damage i used trim remover tools.

I worked my way around with tool 1 to loosen then with tool 1 still in place along the bottom long edge i put tool 4 in there and pulled it out with no damage to either part. The Badge is some 3-4mm thick and metal (like a belt buckle) so no chance of bending it.

Also tool 4 is going to be handy for removing stubborn fuel/vacuum hoses.

Attachment: Trim removal tools.jpg (Downloaded 67 times)

Last edited on 10-10-2016 11:03 am by qwerty

Back To Top PM Quote Reply  

Current time is 07:02 pm  
> Jensen Healey & Jensen GT Tech > Body & interior stuff > STEERING WHEEL REMOVAL Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems