| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Bonnet release cable | Rate Topic |
| Author | Post |
|---|
| Posted: 04-02-2010 08:00 pm |
|
1st Post |
|
Jim Mckeon Member 
|
I went to "pop" the bonnet today and it was a little stiff so I gave it a good tug and the "T" handle comes off in my hand. Has this happened to anyone else out there? Can the handle be reattached (epoxy?) or is a new cable necessary? Thanks..
|
||||||||||||||
| |||||||||||||||
| Posted: 04-07-2010 08:22 am |
|
2nd Post |
|
Jim Mckeon Member
|
OK..the "fix is in", or so it seems. Talked to Jeff at Delta and this is not an uncommon experience. A dab of epoxy in the handle orifice, slightly hammerd back on to the grooved extension of the cable and 24 hours later, back in business. I also took advantage of the opportunity to lube the entire length of the cable in the sheath (one must remove the cable first,of course). Love these cars! Last edited on 04-11-2010 05:56 am by Jim Mckeon |
|||||||||||||
| ||||||||||||||
| Posted: 04-07-2010 02:20 pm |
|
3rd Post |
|
Brett Gibson JH5 20497 Member
|
Jim, I have not used the cable in years to open the bonnet, the one time I did I ended up scrapping my knuckles pretty good, since then I just reach under the bumper and release it that way. Glad to hear yours works better than mine. Brett
|
||||||||||||||
| |||||||||||||||
| Current time is 08:26 pm | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Bonnet release cable | Top |
