| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Another steering wheel question | Rate Topic |
| Author | Post |
|---|
| Posted: 05-17-2005 03:26 am |
|
1st Post |
|
George Member
|
I am going to be reassembling my steering wheel and was wondering about the little circular metal thing that is in two pieces, one of which gets lost in the carpet. Once you find both pieces and go to put it on the column, it looks like the tapered side faces toward the wheel, rather than the dash, is that true? It also seems I should clean and lubricate the stalk switches. After cleaning with electronics cleaning stuff, should I use something to lubricate them? Thanks. Tomorrow - back on the road!
|
||||||||||||||
| |||||||||||||||
| Posted: 05-17-2005 04:20 am |
|
2nd Post |
|
Tim Murphy Member 
|
That little metal thing that is in two pieces is what keeps your steering wheel from jamming into the turn signal switch. I was told (by someone who should have know better at DMS many years ago) that it was not really important or necessary. I went through two cracked switch units - not an inexpensive lesson. I am not sure which side faces toward the wheel. Use a heavy grease to hold the pieces in place when you slip on the wheel. I also have an extra set in my parts bin.
|
|||||||||||||
| ||||||||||||||
| Posted: 05-17-2005 12:28 pm |
|
3rd Post |
|
Brett Gibson JH5 20497 Member
|
George, yes you are correct taper side fit's into the steering wheel, put a little heavey grease on it to hold it in place, as for cleaning the stalk switch's if they work fine now and you dont have an issue with them, I'd leave them alone, should it muck them up they are hard to come by. Bruce Madden in Atlanta told me one time that he rebuilds them, I took mine apart once and the springs went flying all over it took me the better part of a week and a half to get it all back toghter and working, definatley not something I would recommend, next time I'll send it off to Bruce. Good Luck. Brett
|
||||||||||||||
| |||||||||||||||
| Posted: 05-17-2005 05:19 pm |
|
4th Post |
|
Mark Rosenbaum Member 
|
I never had much luck using grease to hold the 'split collar' pieces to the steering shaft, but have found that silicon gasket sealer works well if the various parts are first degreased. If you place the turn signal / headlight / horn switch inside a large plastic bag, you're less likely to lose the various little bits that will certainly spring out when you dismantle the thing. Getting all these bits to stay in place during reassembly takes patience and good manual dexterity. However, disassembly shouldn't be necessary unless internal parts or wires are broken. An aerosol cleaner will usually suffice for the rollers used in the turn signal switch. The headlight high/low contacts are in plain view and readily accessible. The horn switch contacts are attached to the end of the stalk and can be reached by unscrewing the cap on the end of the knob.
|
|||||||||||||
| ||||||||||||||
| Posted: 05-17-2005 09:06 pm |
|
5th Post |
|
Jim Ketcham Member
|
As a point of interest, I recall my steering collars were originally held in place by a small rubber band. I thought this to be a little quirky, but it actually appears in the parts manual and is what the factory appeared to do. Jim
|
||||||||||||||
| |||||||||||||||
| Current time is 06:23 am | |
| > Jensen Healey & Jensen GT Tech > Body & interior stuff > Another steering wheel question | Top |
