Mark Rosenbaum
Member
|
Delta probably has everything you'd need, but it may be rather costly. If you really need to replace the majority of the hardware, it might actually be less expensive to buy a parts car and scavenge from it, then sell the remains. Alternately, you may be able to salvage a lot of the existing hardware if you invest in a tap and die set, and perhaps one of those home plating kits available from a variety of vendors.
Almost all of the engine hardware is metric, typically grade 8.8, though the 12mm studs and nuts used for the head and main bearing saddle might be grade 10.2. If it's critical to keeping the engine together, I do advise buying from Delta -- it's really heartbreaking when an engine blows because a 20-cent part fails.
I'm told that the Getrag 5-speed transmission is entirely metric, though its design is old enough that some of its hardware may use one of the not-current-standard metric threads of which the Germans were once so fond. I suppose that the best way to deal with the situation would be to buy the correct parts from a reputable vendor.
Some parts for the Stromberg carburetors, 4-speed transmission, and differential may use a variety of British threads. In some cases, just identifying the thread will be a bit of a challenge. Here, buy spares and scavenge from them, or buy the correct part from a reputable vendor.
Most of the remaining hardware, including the critical suspension bolts, is cadmium plated Grade 5 stuff using SAE threads. The style of lock nut most often used isn't too common in the US but should be available. In many cases, though, you can use Nylock lock nuts or even regular nuts and lock washers.
Unfortunately, many of the smaller hardware items are likely to be a bit difficult to find in the US. This is due primarily to the use of Pozidrive rather than Phillips heads, but there are also a variety of pilot point screws that aren't ever seen at the local hardware store. The hex head on the #10-32 screws used in a lot of places is the 'small pattern' head which is very rarely used in the US. And some of the bits used to attach the bodywork trim are just plain peculiar even by British standards.
Good luck in getting your car restored.
|
