 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 03-12-2005 |
| Location: | Mesa, Arizona USA |
| Posts: | 340 |
| Status: |
Offline
|
The speedo cable I'm looking at is out of the car. On each end on the inside cable the ends are square shaped. What you see on the speedo side is the same as the trans side. If you pulled out the inside part to feel that the cable is moving, the other end was probably pulled out also.
You might be able to push it back in but probably will need to get underneath the car, loosen the bolt holding the speedo cable in, pull out the cable, push or pull the inner cable on the trans side til it wont go any further, put back in the trans, tighten the bolt, hook up the speedo side and try again.
If you pull the speedo side out some you should see a stop so the cable can not be pulled out from the trans side.
Art