View single post by Art DeKneef
 Posted: 03-18-2010 05:46 am
PM Quote Reply Full Topic
Art DeKneef

 

Joined: 03-12-2005
Location: Mesa, Arizona USA
Posts: 338
Status: 
Offline
 Anybody do something like that? What did you do for the holes in the head for the tubes on the exhaust side?

I am taking off the original cast exhaust off the GT engine and replace with a set of Delta headers. Unfortunately some of the tubes above the exhaust broke while trying to remove the bolts holding them to the head. Didn't have any room to get to the upper exhaust bolts.

Since I'm pretty sure this tube piece is pretty extinct, I'm wondering if just plugging the eight holes will work or does something else need to be done because of the fitting with the small diameter tube that goes into the head.