 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 02-20-2009 |
| Location: | San Rafael, California USA |
| Posts: | 28 |
| Status: |
Offline
|
Thanks for the information. I dont know if i want to re-engineer the Volvo Calipers, but i will look at the 70's Jaguar XJ12 calipers, Porsche 944 calipers and revisit the Toyota 4 Runner calipers. Preliminary review of the Toyota calipers may be a tight fit but may work as long a the mounting holes are rebushed and drilled for the 10mm bolts used on the JH. Provided this caliper would clear the upper A arm when fully turned to the stops (without major modifications) a 1/2" spacer is still needed to make it fit inside the stock wheel. Is there any recommendation for a minimum clearance between wheel and caliper?
Frrancis G