 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | 09-17-2009 |
| Location: | |
| Posts: | 5 |
| Status: |
Offline
|
Attachment: clamp fix.jpg (Downloaded 142 times)
| View single post by mikebfoy | |||||||||||||
| Posted: 09-20-2009 02:57 am |
|
||||||||||||
mikebfoy
|
I fixed a broken compression collar for the signal and wiper levers using a portion of a hose clamp. It is better than new and not difficult to do. I simply drilled 2 holes and used 2 flush head 4-40 screws and nuts to hold in a portion of a hose clamp. I cut out a section of the hose clamp to replace the side of the compression clamp that broke off. I created a counter bore so that the flush head screws became recessed and did not interfere with the steering column. I also used a hammer to sink the screw head into the holes I drilled into the clamp as well. It took about 30 min and the result is rock solid. Attachment: clamp fix.jpg (Downloaded 142 times)
|
||||||||||||
|
| |||||||||||||